Toyota Tacoma (2015-2018) Service Manual: Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART
Navigation System|
DTC Code |
Detection Item |
See page |
|---|---|---|
|
B1324 |
Lost Communication with Meter |
|
|
B1532 |
LVDS Signal Malfunction (from Extension Module) |
|
|
B1551 |
HD Radio Tuner Malfunction |
|
|
B1552 |
Extension Module Malfunction |
|
|
B156C |
Extension Module Disconnected |
|
|
B1579 |
Voice Recognition Microphone Disconnected |
|
|
B1585 |
USB Media Malfunction |
|
|
B158A |
Extension Module Noise Adjustment Malfunction |
|
|
B158C |
SD Card Communication Malfunction |
|
|
B158F |
AV Signal Stoppage (Low Battery Voltage) |
|
|
B15A0 |
LAN Master Malfunction |
|
|
B15A3 |
Stereo Component Amplifier Malfunction |
|
|
B15AD |
Navigation Processor Malfunction |
|
|
B15B0 |
Display Screen Malfunction |
|
|
B15B3 |
Radio Tuner Malfunction |
|
|
B15B4 |
CD Changer Malfunction |
|
|
B15B7 |
Bluetooth Module Malfunction |
|
|
B15BA |
XM Tuner Malfunction |
|
|
B15C0 |
Short in GPS Antenna |
|
|
B15C1 |
Open in GPS Antenna |
|
|
B15C2 |
Speed Signal Malfunction |
|
|
B15C3 |
Speaker Output Short |
|
|
B15D3 |
Stereo Component Amplifier Disconnected |
|
|
B15F5 |
A/C ECU Vehicle Information Reading/Writing Processor Malfunction |
|
|
B15F6 |
Main Body ECU Vehicle Information Reading/Writing Process Malfunction |
|
|
B15F7 |
Certification ECU Vehicle Information Reading/Writing Process Malfunction |
|
|
B15FE |
XM Tuner Antenna Disconnected |
|
|
B15FF |
XM Tuner Antenna Short |
|
|
U0073 |
Sending Malfunction (Navigation to APGS) |
|
|
U0100 |
Lost Communication with ECM / PCM "A" |
|
|
U0129 |
Lost Communication with Brake System Control Module |
|
|
U0140 |
Lost Communication with Body Control Module |
|
|
U0155 |
Meter ECU Communication |
|
|
U0164 |
Lost Communication with A/C ECU |
|
.gif)
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when dec ...
Lost Communication with Meter (B1324)
DESCRIPTION
This DTC is stored when a communication error occurs between the navigation receiver
assembly and combination meter assembly.
DTC No.
DTC Detection Condition
...
Other materials:
Test Mode Procedure
TEST MODE PROCEDURE
1. WARNING LIGHT AND INDICATOR LIGHT INITIAL CHECK
(a) When the ignition switch is turned ON, check that the ABS warning, brake
warning, and slip indicator lights come on for approximately 3 seconds.
HINT:
When the brake fluid level is low, the brake warning light c ...
4WD Control ECU Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
4WD Control ECU Communication Stop Mode
Either condition is met:
Communication stop for "Four Wheel Drive Control" is indicated
on the "Communication Bus C ...
Front Occupant Classification Sensor LH Collision Detection (B1785)
DESCRIPTION
DTC B1785 is set when the occupant detection ECU receives a collision detection
signal, which is sent by the occupant classification sensor front LH when an accident
occurs.
DTC B1785 is also set when the front seat with adjuster frame assembly RH is
subjected to a strong impact, ...
