DIAGNOSIS SYSTEM
1. DLC3 (Data Link Connector 3)
(a) Check the DLC3 (See page
).
2. BATTERY VOLTAGE
Standard voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery.
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
Charging System
Symptom
Suspected Area
See page
Charging System Warning Displayed
Battery
...
Terminals Of Ecm
TERMINALS OF ECM
1. CHECK ECM
HINT:
The standard normal voltage between each pair of ECM terminals is shown in the
table below. The appropriate conditions for checking each pair of terminals ar ...
Related Tacoma materials
Manual Transmission Operation
Operating instructions
Shifting the shift lever
1. Fully depress the clutch pedal before moving the shift lever. Keep the pedal firmly pressed while selecting the next gear.
2. Move the shift lever into the desired gear position.
Change gears only in sequential order. Following the proper ...
Steering Angle Sensor Output Malfunction (C1434)
DESCRIPTION
Steering angle sensor signals are input to the skid control ECU (brake actuator
assembly) via the CAN communication system.
HINT:
When a malfunction occurs in the communication line to the steering angle sensor,
U0126 is output. If a DTC related to the CAN communication line is ou ...
Noise Occurs
PROCEDURE
1.
NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear
left or right).
OK:
The location of the noise source can be determined.
NG
GO TO STEP 3
OK
...