TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Audio And Visual System / Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

Toyota Tacoma (2015-2018) Service Manual: Data Signal Circuit between Radio Receiver and Stereo Jack Adapter

DESCRIPTION

The No. 1 stereo jack adapter assembly sends the sound data signal or image data signal from a USB device to the radio and display receiver assembly via this circuit.

WIRING DIAGRAM

PROCEDURE

PROCEDURE

1.

CHECK HARNESS AND CONNECTOR (RADIO AND DISPLAY RECEIVER ASSEMBLY - NO. 1 STEREO JACK ADAPTER ASSEMBLY)

(a) Disconnect the R28 radio and display receiver assembly connector.

(b) Disconnect the N3 No. 1 stereo jack adapter assembly connector.

(c) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

N3-2 (UDO-) - R28-2 (UDO-)

Always

Below 1 Ω

N3-3 (UDO+) - R28-3 (UDO+)

Always

Below 1 Ω

N3-2 (UDO-) - Body ground

Always

10 kΩ or higher

N3-3 (UDO+) - Body ground

Always

10 kΩ or higher
OK

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR
    Related Tacoma materials

    Manual Transmission Operation
    Operating instructions  Shifting the shift lever 1. Fully depress the clutch pedal before moving the shift lever. Keep the pedal firmly pressed while selecting the next gear. 2. Move the shift lever into the desired gear position. Change gears only in sequential order. Following the proper ...

    Diagnostic Trouble Code Chart
    DIAGNOSTIC TROUBLE CODE CHART If a DTC is displayed during the DTC check, check the parts listed in the table below and proceed to the "See page" given. *1: "Comes on" means the Malfunction Indicator Lamp (MIL) illuminates. *2: "DTC stored" means ...

    Precaution
    PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...