TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Seat / Seat Heater System / Data List / Active Test

Toyota Tacoma (2015-2018) Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

1. DATA LIST

HINT:

Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

NOTICE:

In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Data List.

(e) Read the Data List according to the display on the Techstream.

Air Conditioner

Tester Display

Measurement Item/Range

Normal Condition

Diagnostic Note

FR Seat Heater Temperature

Front seat RH side seat heater temperature / min: -29.7°C or max: 59.55°C

Within range from 36 to 42.2°C (96 to 108°F)

Front seat heater is on

FL Seat Heater Temperature

Front seat LH side seat heater temperature / min: -29.7°C or max: 59.55°C

Within range from 36 to 42.2°C (96 to 108°F)

Front seat heater is on

Number of Trouble Codes

Number of trouble codes / min: 0 or max: 255

Number of DTCs will be displayed

-
    Related Tacoma materials

    Replacement
    REPLACEMENT CAUTION / NOTICE / HINT NOTICE: Immediately wash off any brake fluid that comes into contact with any painted surfaces. HINT: If any work is done on the brake system or if air in the brake lines is suspected, bleed the air from the system. PROCEDURE 1. FILL RESERVOIR WITH BRAK ...

    Pattern Select Switch Power Mode Circuit
    DESCRIPTION The ECM memory contains the programs for the normal and PWR shift patterns. By following the programs corresponding to the signals from the pattern select switch assembly, park/neutral position switch and other various sensors, the ECM switches the shift solenoid valves on and off, ...

    Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
    DESCRIPTION The No. 1 stereo jack adapter assembly sends the sound signal from an external device to the radio and display receiver assembly via this circuit. If there is an open or short in the circuit, sound cannot be heard from the speakers even if there is no malfunction in the radio and d ...