TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Park Assist / Monitoring / Blind Spot Monitor System / Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

Toyota Tacoma (2015-2018) Service Manual: Blind Spot Monitor Slave Module Beam Axis Inspection Incomplete (C1ABC)

DESCRIPTION

This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.

HINT:

This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that beam axis inspection is performed. Completing the beam axis inspection after replacing a blind spot monitor sensor prevents this DTC from being output.

DTC Code

DTC Detection Condition

Trouble Area

C1ABC

A beam axis inspection has not been performed.

Blind spot monitor sensor RH

PROCEDURE

1.

PROCEED TO TEST MODE (BLIND SPOT MONITOR BEAM AXIS INSPECTION)

(a) Change the blind spot monitor sensor RH to Test Mode using the Techstream.

HINT:

Refer to Blind Spot Monitor Beam Axis Inspection (See page ). ). ).

NEXT

END
    Related Tacoma materials

    Automatic Transmission Unit(for 2gr-fks)
    Components COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ...

    Transmission Fluid Temperature Sensor "A" Performance (P0711)
    DESCRIPTION The No. 1 ATF temperature sensor converts the fluid temperature into a resistance value for use by the ECM. The ECM applies a voltage to the temperature sensor through terminal THO1 of the ECM. The sensor resistance changes with the ATF temperature. As the temperature becomes hi ...

    Short to GND in Outer Mirror Indicator(Slave) (C1AB3)
    DESCRIPTION This DTC is stored when the blind spot monitor sensor RH detects a ground short in the blind spot monitor indicator RH. DTC Code DTC Detection Condition Trouble Area C1AB3 With the blind spot monitor main switch assembly (w ...