TTGuideTacoma manuals & technical reference
Toyota Tacoma (2015-2018) Service Manual / Park Assist / Monitoring / Blind Spot Monitor System / Blind Spot Monitor Master Module (C1AB6)

Toyota Tacoma (2015-2018) Service Manual: Blind Spot Monitor Master Module (C1AB6)

DESCRIPTION

This DTC is stored when the blind spot monitor sensor LH detects an internal malfunction.

DTC Code

DTC Detection Condition

Trouble Area

C1AB6

The blind spot monitor sensor LH (master) detects an internal malfunction.

Blind spot monitor sensor LH

CAUTION / NOTICE / HINT

NOTICE:

When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.

PROCEDURE

1.

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again (See page ).

(b) Recheck for DTCs and check if the same DTC is output again (See page OK: ).

OK:

No DTCs are output.

OK

USE SIMULATION METHOD TO CHECK

NG

REPLACE BLIND SPOT MONITOR SENSOR LH

    Related Tacoma materials

    Terminals Of Ecu
    TERMINALS OF ECU 1. AIRBAG SENSOR ASSEMBLY Terminal No. Terminal Symbol Destination A21-1 P2+ Instrument panel passenger without door airbag assembly (Front passenger side squib 2nd step) A21-2 ...

    TC and CG Terminal Circuit
    DESCRIPTION DTC output mode is set by connecting terminals TC and CG of the DLC3. The DTCs are displayed by blinking the SRS warning light. HINT: Make sure that DTCs which relate to the CAN communication system are not output. If any of these DTCs are output, check the CAN communicat ...

    Reassembly
    REASSEMBLY PROCEDURE 1. INSTALL MASTER CYLINDER RESERVOIR GROMMET (a) Apply lithium soap base glycol grease to 2 new grommets. (b) Install the 2 grommets onto the brake master cylinder reservoir. 2. INSTALL BRAKE MASTER CYLINDER RESERVOIR ASSEMBLY (a) Install the brake master cylinder reservoi ...