Toyota Tacoma (2005–2015) Owners Manual: When trouble arises
- Steps to take in an emergency
- If a warning light turns on or a warning buzzer sounds
- If you have a flat tire
- If the engine will not start
- If the shift lever cannot be shifted from P (vehicles with an automatic transmission)
- If you lose your keys
- If the vehicle battery is discharged
- If your vehicle overheats
- If the vehicle becomes stuck
- If your vehicle has to be stopped in an emergency
Light bulbs
You may replace the following bulbs yourself. The difficulty level of replacement
varies depending on the bulb. If necessary bulb replacement seems difficult to perform,
contact your Toyota dealer ...
Other materials:
Inspection
INSPECTION
PROCEDURE
1. INSPECT MAGNET STARTER SWITCH ASSEMBLY
(a) Inspect the pull-in coil.
(1) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
Terminal 50
*b
...
Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
If the millimeter wave radar sensor assembly has been struck or dropped, replace
the millimeter wave radar sensor assembly with a new one.
PROCEDURE
1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
(a) for Type A:
(1) Engage the 2 gu ...
Terminals Of Ecu
TERMINALS OF ECU
1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND DRIVER SIDE JUNCTION
BLOCK
(a) Remove the main body ECU (multiplex network body ECU) from the driver side
junction block (See page ).
(b) Disconnect the 1D driver side junction block connector.
(c) Measure the voltag ...
