Toyota Tacoma (2015-2018) Service Manual: Vehicle Speed Sensor (C1A45)
DESCRIPTION
The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication.
|
DTC Code |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
C1A45 |
A fail flag is transmitted from the skid control ECU (brake actuator assembly). |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor main switch assembly (warning canceling switch assembly) is on.
PROCEDURE
|
1. |
CHECK DTC (VEHICLE STABILITY CONTROL SYSTEM) |
(a) Check for vehicle stability control system DTCs.
- for Hydraulic Brake Booster (See page
.gif)
) - for Vacuum Brake Booster (See page
)
OK:
Vehicle stability control system DTCs are not output.
Result|
Result |
Proceed to |
|---|---|
|
OK |
A |
|
NG (for Hydraulic Brake Booster) |
B |
|
NG (for Vacuum Brake Booster) |
C |
| B | .gif) |
GO TO VEHICLE STABILITY CONTROL SYSTEM |
| C | |
GO TO VEHICLE STABILITY CONTROL SYSTEM |
|
.gif)
|
2. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check if the same DTC is output again (See page
).
|
Result |
Proceed to |
|---|---|
|
No DTC is output |
A |
|
DTC is output from the blind spot monitor sensor LH (master) |
B |
|
DTC is output from the blind spot monitor sensor RH (slave) |
C |
| A | |
USE SIMULATION METHOD TO CHECK |
| B | |
REPLACE BLIND SPOT MONITOR SENSOR LH |
| C | |
REPLACE BLIND SPOT MONITOR SENSOR RH |
Short to +B in Outer Mirror Indicator(Slave) (C1AB1)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor RH detects a +B short in
the blind spot monitor indicator RH.
DTC Code
DTC Detection Condition
Tr ...
Short to +B in Outer Mirror Indicator(Master) (C1AB0)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH detects a +B short in
the blind spot monitor indicator LH.
DTC Code
DTC Detection Condition
Tr ...
Other materials:
Lost Communication With ECM/PCM "A" Missing Message (U010087)
DESCRIPTION
The engine control unit and transmission control unit are located inside the
ECM. The engine control unit intercommunicates with the transmission control ECU
via CAN communication. If there is a problem in this intercommunication, the ECM
stores this DTC.
DTC Code
...
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
disconnecting the cable from the negative (-) battery terminal notices before pr ...
System Description
SYSTEM DESCRIPTION
1. DESCRIPTION OF SYSTEM
(a) When the tire pressure warning system detects that the tire pressure of a
tire is lower than the threshold, it will inform the driver using a warning light.
(b) The tire pressure warning ECU and receiver receives the transmitter ID, temperature
...
