Toyota Tacoma (2015-2018) Service Manual: Status Signal Circuit

Toyota Tacoma (2015-2018) Service Manual / Other System / Wireless Charging System / Status Signal Circuit

DESCRIPTION

This circuit sends a smart key system status signal from the certification ECU (smart key ECU assembly) to the mobile wireless charger cradle assembly. Based on this signal, the mobile wireless charger cradle assembly suspends or resumes wireless charging.

WIRING DIAGRAM

CAUTION / NOTICE / HINT

NOTICE:

Before replacing the certification ECU (smart key ECU assembly), refer to the Registration ( PROCEDURE ).

PROCEDURE

1.	INSPECT MOBILE WIRELESS CHARGER CRADLE ASSEMBLY

(a) Measure the voltage according to the value(s) in the table below.

Text in Illustration

*a	Component with harness connected (Mobile Wireless Charger Cradle Assembly)

Standard Voltage:

Tester Connection	Condition	Specified Condition
M5-10 (DIS) - Body ground	For 1500 ms after turning ignition switch from off to on (IG)*1	4.4 to 6.5 V
	Being charged	Below 1 V
	Charging suspended due to smart key system status*2	4.4 to 6.5 V

HINT:

*1: The mobile wireless charger cradle assembly checks the status signal for 1500 ms when the ignition switch is turned from off to on (IG). If a status signal voltage of less than 1 V continues for 400 ms or more during the check, the mobile wireless charger cradle assembly judges that the status signal is interrupted, blinks the indicators and stops the operation until the ignition switch is turned off then on (IG) again.
*2: For the status of the smart key system when charging is stopped temporarily, refer to System Description (See page ).

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

2.	CHECK HARNESS AND CONNECTOR (MOBILE WIRELESS CHARGER CRADLE ASSEMBLY - CERTIFICATION ECU (SMART KEY ECU ASSEMBLY))

(a) Disconnect the M5 mobile wireless charger cradle assembly connector.

(b) Disconnect the C28 certification ECU (smart key ECU assembly) connector.

Standard Resistance:

Tester Connection	Condition	Specified Condition
M5-10 (DIS) - C28-21 (ASEL)	Always	Below 1 Ω
M5-10 (DIS) - Body ground	Always	10 kΩ or higher

REPLACE CERTIFICATION ECU (SMART KEY ECU ASSEMBLY)

REPAIR OR REPLACE HARNESS OR CONNECTOR

Main Switch Signal Circuit

DESCRIPTION When the wireless charger main switch (mobile wireless charger switch) is turned on, this circuit sends an on signal to the mobile wireless charger cradle assembly using the power sup ...

Wireless Charger Illumination Circuit

DESCRIPTION When the light control switch is turned to the tail or head position, this circuit sends an illumination signal to the mobile wireless charger cradle assembly. Based on this signal, t ...

Other materials:

Rear Door(for Double Cab)
Components COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION ILLUSTRATION Adjustment ADJUSTMENT CAUTION / NOTICE / HINT HINT: Use the same procedures for both the LH and RH sides. The procedure described below is for the LH side. Centering bolts ...

System Description
SYSTEM DESCRIPTION 1. GENERAL (a) The blind spot monitor system has the blind spot monitor function and rear cross traffic alert function. (1) Blind spot monitor function The blind spot monitor function is a function that assists the driver in making the decision to change lanes. Th ...

Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a forward recognition camera system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignit ...