Toyota Tacoma (2015-2018) Service Manual: Repair
REPAIR
PROCEDURE
1. REPAIR INTAKE VALVE SEATS
NOTICE:
- Repair the intake valve seat while checking the seating position.
- Keep the lip free of foreign matter.
|
(a) Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification. |
|
|
(b) Using 30° and 60° cutters, correct the valve seat so that the intake valve contacts the entire circumference of the seat. The contact should be in the center of the intake valve seat, and the intake valve seat width should be maintained within the specified range around the entire circumference of the intake valve seat. Text in Illustration
Standard width: 1.1 to 1.5 mm (0.0433 to 0.0591 in.) |
|
(c) Hand-lap the intake valve and intake valve seat with an abrasive compound.
(d) Check the intake valve seating position.
2. REPAIR EXHAUST VALVE SEATS
NOTICE:
- Repair the seat while checking the seating position.
- Keep the lip free of foreign matter.
|
(a) Using a 45° cutter, resurface the valve seat so that the valve seat width is more than the specification. |
|
|
(b) Using 30° and 75° cutters, correct the exhaust valve seat so that the exhaust valve contacts the entire circumference of the seat. The contact should be in the center of the exhaust valve seat, and the exhaust valve seat width should be maintained within the specified range around the entire circumference of the exhaust valve seat. Text in Illustration
Standard width: 1.3 to 1.7 mm (0.0512 to 0.0669 in.) |
|
(c) Hand-lap the exhaust valve and exhaust valve seat with an abrasive compound.
(d) Check the exhaust valve seating position.
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
HINT:
Perform "Inspection After Repairs" after replacing the cylinder head sub-assembly
or cylinder head LH (See page ).
PROCEDURE
1. INSTALL SPARK ...
Other materials:
Rear differential lock system
The rear differential lock system is provided for use only when wheel spinning
occurs in a ditch or on a slippery or rugged surface.
The rear differential lock system is effective in case one of the rear wheels
is spinning.
Press the RR DIFF LOCK switch to lock the rear differential.
At thi ...
Vehicle Speed Signal Circuit between Radio Receiver and Combination Meter
DESCRIPTION
for Navigation Function:
The navigation receiver assembly receives a vehicle speed signal from
the combination meter assembly and sends the signal to navigation receiver
assembly.
for Automatic Sound Levelizer (ASL):
This circuit is necessary for the Aut ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL EXHAUST MANIFOLD SUB-ASSEMBLY LH
(a) Install a new gasket to the cylinder head LH.
NOTICE:
Be careful of the installation direction.
(b) Temporarily install the exhaust manifold sub-assembly LH with the 4 nuts.
(c) Tighten the 4 nuts in the sequenc ...
