Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / 2gr-fks Engine Control / Camshaft Oil Control Valve(for Exhaust Side Of Bank 2) / Removal

REMOVAL

CAUTION / NOTICE / HINT

NOTICE:

If one of the camshaft timing gear bolts is already removed, do not remove any other camshaft timing gear bolts.

PROCEDURE

1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package)

2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY

3. REMOVE CAMSHAFT TIMING OIL CONTROL SOLENOID ASSEMBLY

(See page 4. SET NO. 1 CYLINDER TO TDC/COMPRESSION )

4. SET NO. 1 CYLINDER TO TDC/COMPRESSION

(a) Turn the crankshaft clockwise to align the timing mark (cutout) on the crankshaft pulley assembly with the "0" timing mark on the timing chain cover assembly.

Text in Illustration

*a	"0" Timing Mark
*b	Timing Mark (Cutout)

(b) Check that the end of the spring inside of the camshaft timing gear assembly is as shown in the illustration.

Text in Illustration

*a	Spring End

HINT:

If the end of the spring is not as shown in the illustration, rotate the crankshaft clockwise 360° and align the timing marks again.

5. REMOVE CAMSHAFT TIMING GEAR BOLT

(a) Using SST, hold the crankshaft pulley assembly.

SST: 09213-54015

91651-60855

SST: 09330-00021

(b) Remove the camshaft timing gear bolt.

NOTICE:

Replace with a new part if it is dropped or if it receives a strong impact.

Installation

INSTALLATION PROCEDURE 1. SET NO. 1 CYLINDER TO TDC/COMPRESSION 2. INSTALL CAMSHAFT TIMING GEAR BOLT NOTICE: There are different types of camshaft timing gear bolts. Make sure to check the i ...

Camshaft Oil Control Valve(for Intake Side Of Bank 1)

...

Other materials:

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU) AND DRIVER SIDE JUNCTION BLOCK (a) Disconnect the main body ECU (multiplex network body ECU) connectors. Text in Illustration *1 Main Body ECU (Multiplex Network Body ECU) - - ...

Registration
REGISTRATION PROCEDURE 1. DESCRIPTION OF CODE REGISTRATION (a) w/ Wireless Door Lock Control System: The key has 2 codes: the key code (immobiliser code) and the wireless code. Both of these codes need to be registered. For the wireless code registration procedures, refer to Wireless Door Lo ...

XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION These DTCs are stored when a malfunction occurs in the antenna assembly with holder which is connected to the navigation receiver assembly assembly. DTC No. DTC Detection Condition Trouble Area B15FE The antenna assembly wi ...