Toyota Tacoma (2015-2018) Service Manual: Removal

Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Side Airbag Sensor(for Double Cab) / Removal

REMOVAL

CAUTION / NOTICE / HINT

HINT:

Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page NOTICE: ).

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

Wait for at least 90 seconds after disconnecting the cable to prevent the airbag from working.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE FRONT DOOR SCUFF PLATE

3. REMOVE FRONT DOOR SCUFF PLATE

4. REMOVE REAR DOOR SCUFF PLATE

5. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP

6. DISCONNECT REAR DOOR OPENING TRIM WEATHERSTRIP

7. REMOVE LAP BELT OUTER ANCHOR COVER

8. REMOVE CENTER PILLAR LOWER GARNISH

9. REMOVE SIDE AIRBAG SENSOR ASSEMBLY

(a) Disconnect the connector from the side airbag sensor.

NOTICE:

When disconnecting any airbag connector, take care not to damage the airbag wire harness.

(1) Push and hold the white housing lock, and slide the yellow outer connector locking sleeve.

(2) Push and hold the white housing lock again, and slide the yellow outer connector locking sleeve to disconnect the connector.

(b) Remove the bolt and side airbag sensor.

NOTICE:

Loosen the bolt while holding the door side airbag sensor because the side airbag sensor pin (stopper) is easily damaged.

On-vehicle Inspection

ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT SIDE AIRBAG SENSOR ASSEMBLY (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). 2. INSPECT SIDE AIRBAG SENSOR AS ...

Spiral Cable

...

Other materials:

Removal
REMOVAL PROCEDURE 1. REMOVE TIMING CHAIN COVER ASSEMBLY (See page ) 2. SEPARATE NO. 2 WATER BY-PASS PIPE (for Vacuum Brake Booster) 3. REMOVE VACUUM PUMP ASSEMBLY (for Vacuum Brake Booster) 4. SET NO. 1 CYLINDER TO TDC/COMPRESSION 5. REMOVE NO. 1 CHAIN TENSIONER ASSEMBLY 6. REMO ...

Cruise Control Main Switch
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE STEERING PAD ASSEMBLY (See page ) 2. REMOVE CRUISE CONTROL MAIN SWITCH (a) Disconnect the connector and remove the 2 screws. (b) Remove the cruise ...

Dtc Check / Clear
DTC CHECK / CLEAR 1. DTC CHECK USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Air Conditioner / Trouble Codes. (e) Check for DTCs. 2. DTC CLEAR USING TECHSTREAM (a) Conn ...