Toyota Tacoma (2015-2018) Service Manual: Rear Seat Inner Belt Assembly(for Access Cab)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR NO. 1 SEAT INNER BELT ASSEMBLY
(a) Open the 2 anchor covers.
|
(b) Loosen the 2 bolts to remove the 2 rear No. 1 seat inner belt assemblies. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR NO. 1 SEAT INNER BELT ASSEMBLY
(a) Tighten the 2 bolts to install the 2 rear No. 1 seat inner belt assemblies.
Torque:
42 N·m {428 kgf·cm, 31 ft·lbf}
(b) Check that the floor anchor rotates smoothly.
(c) Close the 2 anchor covers.
Rear Center Seat Outer Belt Assembly(for Double Cab)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE REAR SEATBACK HINGE COVER
2. REMOVE REAR SEATBACK BOARD SUB-ASSEMBLY
3. REMOVE SEAT BELT ANCHOR COVER CAP
...
Rear Seat Inner Belt Assembly(for Double Cab)
Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR SEAT INNER BELT ASSEMBLY
(a) for LH Side:
(1) Install the rear seat inner belt assembly with the bolt.
Text in Illustration
...
Other materials:
Active head restraints (Access Cab and Double Cab models only)
When the occupant’s back presses against the seatback during a rear-end collision,
the head restraint moves slightly forward to help reduce the risk of whiplash on
the seat occupant.
■Active head restraints
Even small forces applied to the seatback may cause the head restraint to mov ...
Position Initialization Incomplete (B2343)
DESCRIPTION
This DTC is stored when the sliding roof ECU (sliding roof drive gear sub-assembly)
has not been initialized.
DTC No.
DTC Detection Condition
Trouble Area
B2343
Sliding roof ECU (sliding roof drive gear sub-assembly) has no ...
Transfer Shift Motor Control Circuit High (P17AA)
DESCRIPTION
This DTC is output when a short to B+ in the transfer shift motor and A.D.D.
shift motor drive circuit is detected.
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
P17AA
Transfer Shift Motor Control C ...
