Toyota Tacoma (2015-2018) Service Manual: Lost Communication with Vehicle Dynamics Control Module Missing Message (U012287)
DESCRIPTION
The ECM receives signals from the skid control ECU (brake actuator assembly) via CAN communication.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
MIL |
Note |
|---|---|---|---|---|
|
U012287 |
While cruise control main switch ON, communication stop between skid control ECU (brake actuator assembly) continues for 2.6 seconds or more |
|
Does not come on |
SAE: U0122 |
CAUTION / NOTICE / HINT
HINT:
Refer to troubleshooting in CAN Communication System (See page
.gif)
).
PROCEDURE
|
1. |
CHECK FOR DTC |
(a) Clear the DTCs (See page ).
(b) Perform the following to make sure that the DTC detection conditions are met.
HINT:
If the detection conditions are not met, the malfunction cannot be detected.
(1) Drive the vehicle at a speed for which cruise control operation is possible.
(2) Turn the cruise control system on using the cruise control main switch (ON/OFF).
(3) Push the cruise control main switch to -SET to begin control of vehicle speed using the cruise control system.
(c) Check the DTCs (See page ).
OK:
DTC U012287 is not output
| OK | .gif) |
USE SIMULATION METHOD TO CHECK |
| NG | |
GO TO CAN COMMUNICATION SYSTEM |
Cruise Control System Internal Failure (P057504,P057549)
DESCRIPTION
This is output when the ECM detects malfunctions in the internal circuit.
DTC Code
DTC Detection Condition
Trouble Area
MIL
Note
...
Vehicle Control History
VEHICLE CONTROL HISTORY
VEHICLE CONTROL HISTORY
(a) A part of the control history can be confirmed using the vehicle control
history.
Click here ...
Other materials:
Brake Booster Pump Motor on Time Abnormally Long (C1252)
DESCRIPTION
The motor relay (semiconductor relay) is built into the master cylinder solenoid
and drives the pump motor based on a signal from the skid control ECU (master cylinder
solenoid).
DTC No.
DTC Detecting Condition
Trouble Areas
C1252
...
Security Indicator Light Does not Blink
DESCRIPTION
The transponder key ECU assembly blinks the security indicator light
when the immobiliser is set (no key is in the ignition key cylinder).
w/ Theft Deterrent System:
The main body ECU (multiplex network body ECU) blinks the security indicator
light when the thef ...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
When installing the hood bulge protector, heat the hood bulge surface
using the infrared light.
Do not heat the hood bulge excessively.
Item
Temperature
Hood Bulge
...
