Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Inspection

INSPECTION

PROCEDURE

1. INSPECT TIE ROD END SUB-ASSEMBLY

(a) Flip the ball joint stud back and forth 5 times as shown in the illustration

(a) Flip the ball joint stud back and forth 5 times as shown in the illustration before installing the nut.

(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds per turn and check the torque reading on the 5th turn.

Torque:

0.49-3.43 N·m {5.0-35.0 kgf·cm, 4.34-30.36 in·lbf}

2. INSPECT POWER STEERING RACK

(a) Using a dial indicator, check the power steering rack for runout, teeth wear

(a) Using a dial indicator, check the power steering rack for runout, teeth wear and damage.

Maximum runout:

0.3 mm (0.012 in.)

If necessary, replace the power steering link assembly.

(b) Check the back surface for wear and damage.

If necessary, replace the power steering link assembly.

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE STEERING GEAR OUTLET RETURN TUBE (a) Using a union nut wrench, remove the steering gear outlet return tube. 2. REMOVE STEERING TURN PRESSURE TUBE (a) Using a u ...

Installation
INSTALLATION PROCEDURE 1. INSTALL POWER STEERING LINK (a) Insert the power steering link into the vehicle in the order shown in the illustration. Install in this Direction ...

Other materials:

Freeze Frame Data
FREEZE FRAME DATA DESCRIPTION (a) Whenever a forward recognition camera system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data. CHECK FREEZE FRAME DATA (a) Connect the Techstream to the DLC3. (b) Turn the ignit ...

High Beam Headlight Circuit
DESCRIPTION The main body ECU (multiplex network body ECU) controls the high beam headlights. WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Inspect the fuses for circuits related to this system before performing the following inspection procedure. If the main body ECU (multip ...

Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART If a trouble code is indicated while checking DTCs, inspect the circuit listed for that code in the table below, and proceed to the applicable page. Cruise Control System DTC Code Detection Item MIL See page ...

© 2011-2024 Copyright www.ttguide.net