DESCRIPTION
Refer to the system description for DTC P2757 (See page ).
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
P2759 |
Open or short is detected in shift solenoid valve SLU circuit for 1 second or more while driving (1 trip detection logic). |
|
MONITOR DESCRIPTION
When an open or short in a shift solenoid valve SLU circuit is detected, the ECM determines there is a malfunction. The ECM will illuminate the MIL and store this DTC.
MONITOR STRATEGY
Related DTCs |
P2759: Shift solenoid valve SLU/Range check |
Required sensors/Components |
Shift solenoid valve SLU |
Frequency of operation |
Continuous |
Duration |
1 sec. |
MIL operation |
Immediately |
Sequence of operation |
None |
TYPICAL ENABLING CONDITIONS
All:
The monitor will run whenever the following DTCs are not stored |
None |
Ignition switch |
ON |
Starter |
OFF |
Battery voltage |
12 V or higher |
Battery voltage |
10 V or higher, and below 12 V |
Target current |
Below 0.75 A |
Battery voltage |
8 V or higher |
Target current |
0.25 A or higher |
TYPICAL MALFUNCTION THRESHOLDS
One of the following conditions is met: Condition (A), (B) or (C)
Condition (A) and (B):
Output duty cycle |
100% or more |
Output duty cycle |
0% or less |
COMPONENT OPERATING RANGE
Output duty cycle |
More than 3%, and less than 100% |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
HINT:
After the repair, clear the DTCs and perform the following procedure to check that DTCs are not output.
PROCEDURE
1. |
INSPECT TRANSMISSION WIRE (SHIFT SOLENOID VALVE SLU) |
(a) Disconnect the E1 transmission wire connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
21 (SLU+) - 22 (SLU-) |
20°C (68°F) |
5.0 to 5.6 Ω |
21 (SLU+) - Body ground |
Always |
10 kΩ or higher |
22 (SLU-) - Body ground |
Always |
10 kΩ or higher |
*a |
Component without harness connected (Transmission Wire) |
NG |
GO TO STEP 3 |
|
2. |
CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - ECM) |
(a) Disconnect the ECM connector. |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
E19-2 (SLU+) - E19-1 (SLU-) |
20°C (68°F) |
5.0 to 5.6 Ω |
E19-2 (SLU+) - Body ground |
Always |
10 kΩ or higher |
E19-1 (SLU-) - Body ground |
Always |
10 kΩ or higher |
*a |
Rear view of wire harness connector (to ECM) |
OK |
REPLACE ECM |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
3. |
INSPECT SHIFT SOLENOID VALVE SLU |
(a) Remove shift solenoid valve SLU (See page ). |
|
(b) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
1 - 2 |
20°C (68°F) |
5.0 to 5.6 Ω |
(c) Apply 12 V battery voltage to the shift solenoid valve and check that the valve moves and makes an operating noise.
OK:
Measurement Condition |
Specified Condition |
---|---|
|
Valve moves and makes an operating noise |
*1 |
Shift Solenoid Valve SLU |
OK |
REPLACE TRANSMISSION WIRE |
NG |
REPLACE SHIFT SOLENOID VALVE SLU |
Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 FUEL TANK PROTECTOR
(a) Install the No. 1 fuel tank protector to the fuel tank assembly with the
4 clips.
2. INSTALL FUEL SUCTION TUBE SET GASKET
Click here
3. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY
Click here
4. INSTALL FUEL PUMP ...
Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE
1.
CHECK PORTABLE PLAYER SETTINGS
(a) Check the portable player settings.
(1) Check that the volume is not set to "0".
(2) Check that the mute is off.
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound ...
Data List / Active Test
DATA LIST / ACTIVE TEST
1. DATA LIST
NOTICE:
In the table below, the values listed under "Normal Condition" are reference
values. Do not depend solely on these reference values when deciding whether a part
is faulty or not.
HINT:
Using the Techstream to read the Data List allows t ...