TERMINALS OF ECU
1. TERMINAL INSPECTION
Text in Illustration
*a |
Component without harness connected (Steering Lock ECU (Steering Lock Actuator or UPR Bracket Assembly)) |
- |
- |
(a) Measure the voltage and resistance according to the value(s) in the table below.
Terminal No. (Symbol) |
Input/Output |
Wiring Color |
Terminal Description |
Condition |
Specified Condition |
Related Data List Item |
---|---|---|---|---|---|---|
S45-1 (GND) - Body ground |
- |
W-B - Body ground |
Ground* |
Always |
Below 1 Ω |
- |
S45-3 (IGE) - S45-1 (GND) |
Input |
Y - W-B |
Steering lock motor activation command signal (motor activation command signal sent from certification ECU (smart key ECU assembly)) |
Any door opened when conditions below met, and then steering lock motor activated:
|
Pulse generation (see waveform) |
Smart Key
|
S45-4 (SLP1) - S45-1 (GND) |
Output |
BE - W-B |
Steering lock bar position signal (output signal from steering unlock sensor) |
Steering locked → unlocked |
11 to 14 V → Below 1.5 V |
Smart Key
|
S45-5 (LIN) - S45-1 (GND) |
Input/Output |
L - W-B |
LIN communication line |
- |
- |
Smart Key
|
S45-6 (IG2) - S45-1 (GND) |
Input |
B - W-B |
Power source mode signal (IG2 power supply input for entire steering lock actuator assembly)* |
Engine switch off → engine switch on (IG) |
Below 1 V → 11 to 14 V |
- |
S45-7 (B) - Body ground |
Input |
R - Body ground |
Power source* |
Always |
11 to 14 V |
- |
NOTICE:
There is 1 motor and 2 sensors built into the steering lock actuator assembly.
HINT:
(1) Waveform
Item |
Content |
---|---|
Tester Connection |
S45-3 (IGE) - S45-1 (GND) |
Tool Setting |
2 V/DIV., 200 ms./DIV. |
Vehicle Condition |
Steering lock motor not operating → Operating → Not operating |
*a |
Steering Lock Motor not Operating |
*b |
Steering Lock Motor Operating |
Installation
INSTALLATION
CAUTION / NOTICE / HINT
CAUTION:
Wear protective gloves. Sharp areas on the parts may injure your hands.
HINT:
Use the same procedure for both the RH and LH sides.
The procedure described below is for the LH side.
PROCEDURE
1. INSTALL FRONT SEAT AIRBAG ASSEMBLY ...
Removal
REMOVAL
PROCEDURE
1. REMOVE REFRIGERANT FROM REFRIGERATION SYSTEM
2. REMOVE AIR CONDITIONER PRESSURE SENSOR
(a) Disconnect the connector.
(b) Using a 27 mm deep socket wrench, remove the air conditioner pressure
sensor.
T ...
Steering Angle Sensor Communication Stop Mode
DESCRIPTION
Detection Item
Symptom
Trouble Area
Steering Angle Sensor Communication Stop Mode
Either condition is met:
Communication stop for "Spiral cable (Steering Angle Sensor)"
is indicated on the "C ...