REMOVAL
PROCEDURE
1. REMOVE INTAKE MANIFOLD
(See page )
2. REMOVE WIRE HARNESS CLAMP BRACKET
(a) Remove the 2 bolts and wire harness clamp bracket. |
|
3. REMOVE FUEL TUBE SUB-ASSEMBLY
(a) Disconnect the fuel tube sub-assembly from the fuel pump assembly (See page ). |
|
(b) Remove the bolt and fuel tube sub-assembly.
4. REMOVE NO. 1 FUEL PIPE SUB-ASSEMBLY
(a) Loosen the 2 union nuts of the No. 1 fuel pipe sub-assembly.
(b) Remove the No. 1 fuel pipe sub-assembly.
5. REMOVE FUEL PUMP ASSEMBLY
(a) Remove the 2 bolts and fuel pump assembly. |
|
(b) Remove the O-ring from the fuel pump assembly. |
|
(c) Remove the fuel pump lifter guide and fuel pump lifter assembly.
(d) Remove the fuel pump spacer gasket from the cylinder head cover sub-assembly.
Parts Location
PARTS LOCATION
ILLUSTRATION
*A
for Vacuum Brake Booster
*B
for Hydraulic Brake Booster
*1
BRAKE ACTUATOR ASSEMBLY (SKID CONTROL ECU)
*2
BRAKE BOOSTER WITH MASTER CYLINDER ASSEMBLY (SKID CONTROL ECU)
...
Stereo Component Amplifier
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore, make sure to read the
disconnecti ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the causes of the problem symptom.
The potential causes of the symptoms are listed in order of probability
in the "Suspected Area" column of the table. Check each symptom by checking
the suspected area ...