Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Removal

REMOVAL

PROCEDURE

1. PRECAUTION

CAUTION:

Be sure to read Precaution thoroughly before servicing (See page NOTICE: ).

NOTICE:

After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

Click here 2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

NOTICE:

When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

Click here 3. REMOVE FRONT SEAT ASSEMBLY RH

3. REMOVE FRONT SEAT ASSEMBLY RH

Click here 4. REMOVE OCCUPANT DETECTION ECU

4. REMOVE OCCUPANT DETECTION ECU

(a) Disconnect the 2 connectors from the occupant detection ECU.

(a) Disconnect the 2 connectors from the occupant detection ECU.

(b) Disengage the claw to remove the occupant detection ECU.

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT OCCUPANT DETECTION ECU (for Vehicle not Involved in Collision) (a) Perform a diagnostic system check (See page ). 2. INSPECT OCCUPANT DETECTION ECU (fo ...

Installation
INSTALLATION PROCEDURE 1. INSTALL OCCUPANT DETECTION ECU (a) Check that the ignition switch is OFF. (b) Check that the cable is disconnected from the battery negative (-) terminal is disconnecte ...

Other materials:

Antenna Coil Open / Short (B2784)
DESCRIPTION When an open or short circuit is detected in the transponder key amplifier coil built into the engine switch, the certification ECU (smart key ECU assembly) stores this DTC. This DTC is also stored as a past DTC. DTC Code DTC Detection Condition Tro ...

Fail-safe Chart
FAIL-SAFE CHART 1. FAIL-SAFE OPERATION AND DEACTIVATION CONDITION DIFFERENTIAL SYSTEM (w/ Differential Lock) DTC No. Fail-safe Operation Fail-safe Deactivation Condition U0122 All switching prohibited When rear differential is locked ...

On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT FOR COOLANT LEAK HINT: The sliding surface inside the engine water pump assembly is lubricated by engine coolant. As some engine coolant is discharged during normal operation, engine coolant residue (solids) may be found on the drain plu ...

В© 2011-2024 Copyright www.ttguide.net