Toyota Tacoma (2015-2018) Service Manual: Removal
REMOVAL
PROCEDURE
1. REMOVE MANUAL TRANSMISSION ASSEMBLY
(See page .gif)
)
2. REMOVE CLUTCH RELEASE FORK SUB-ASSEMBLY
|
(a) Remove the clutch release fork sub-assembly with the clutch release bearing assembly from the manual transmission assembly. |
|
(b) Remove the release fork support from the manual transmission assembly.
|
(c) Remove the clip and clutch release bearing assembly from the clutch release fork sub-assembly. |
|
(d) Remove the clutch release fork collar from the clutch release fork sub-assembly.
(e) Remove the clutch release fork dust seal from the clutch release fork sub-assembly.
3. REMOVE CLUTCH COVER ASSEMBLY
|
(a) Put matchmarks on the clutch cover assembly and flywheel sub-assembly. Text in Illustration
|
|
(b) Loosen each bolt one turn at a time until spring tension is released.
(c) Remove the 6 bolts and pull off the clutch cover assembly.
NOTICE:
Do not drop the clutch disc assembly.
4. REMOVE CLUTCH DISC ASSEMBLY
NOTICE:
Keep the lining part of the clutch disc assembly, the pressure plate and the surface of the flywheel sub-assembly away from oil and foreign matter.
Inspection
INSPECTION
PROCEDURE
1. INSPECT CLUTCH DISC ASSEMBLY
NOTICE:
When replacing the clutch disc assembly, make sure to perform an inspection of
the flywheel sub-assembly and clutch cover assembly.
...
Installation
INSTALLATION
PROCEDURE
1. INSTALL CLUTCH DISC ASSEMBLY
(a) Insert SST into the clutch disc assembly, and then install SST and the clutch
disc assembly together to the flywheel sub-assembly.
Tex ...
Other materials:
Windshield wipers and washer
■ Without intermittent type
Type A
Low speed windshield wiper
operation
High speed windshield wiper operation
Temporary operation
Washer operation
Type B
Low speed windshield wiper operation
High speed windshield wiper operation
Temporary operation
Washer op ...
Open or Short in Front Speed Sensor RH Circuit (C1405,C1406)
DESCRIPTION
Refer to DTCs C1401 and C1402 (See page ).
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
C1405
Open or Short in Front Speed Sensor RH Circuit
Either of the following is detected:
...
Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
NOTICE:
Do not try to remove the black nylon tube as it is welded to the fuel suction
tube assembly (See page
).
HINT:
Perform "Inspection After Repairs" after replacing the fuel pump (See page
).
PROCEDURE
1. INSTALL FUEL PUMP
HINT:
Perfo ...
