REMOVAL
PROCEDURE
1. REMOVE CLUTCH MASTER CYLINDER ASSEMBLY
(See page )
2. REMOVE TURN OVER SPRING SEAT COMPRESSION SPRING
(a) Remove the compression spring. |
|
3. REMOVE CLUTCH PEDAL SUB-ASSEMBLY
(a) Remove the bolt and nut. |
|
(b) Remove the clutch pedal sub-assembly from the clutch pedal support.
4. REMOVE CLUTCH PEDAL SPRING HOLDER
(a) Remove the clutch pedal spring holder from the clutch pedal support. |
|
5. REMOVE CLUTCH PEDAL PAD
6. REMOVE CLUTCH PEDAL BUSH
(a) Remove the 2 bushes from the clutch pedal sub-assembly. |
|
7. REMOVE CLUTCH PEDAL SHAFT COLLAR
(a) Remove the clutch pedal shaft collar from the clutch pedal sub-assembly. |
|
8. REMOVE CLUTCH PEDAL NO.1 CUSHION
(a) Using needle-nose pliers, remove the clutch pedal No. 1 cushion from the clutch pedal sub-assembly. |
|
Dtc Check / Clear
DTC CHECK / CLEAR
CHECK FOR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Central Gateway / Trouble Codes.
(e) Read the DTCs.
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) ...
Slip Indicator Light Remains ON
DESCRIPTION
The slip indicator light blinks during VSC or TRAC and AUTO LSD operation. When
the system fails, the slip indicator light comes on to warn the driver.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When replacing the skid control ECU (master cylinder solenoid), perform ...
Transmission Fluid Temperature Sensor "B" Circuit Low Input (P2742,P2743)
DESCRIPTION
The No. 2 ATF temperature sensor is installed in the transmission valve body
assembly.
If the ECM detects an abnormally high ATF temperature near this sensor, it illuminates
the warning indicator.
HINT:
The temperature of ATF easily rises when towing, climbing hills, in
...