Toyota Tacoma (2015-2018) Service Manual: Removal
REMOVAL
PROCEDURE
1. DISCONNECT TRANSMISSION WIRE
(See page .gif)
)
2. REMOVE VALVE BODY OIL STRAINER ASSEMBLY
|
(a) Remove the 3 bolts and valve body oil strainer assembly from the transmission valve body assembly. |
|
3. REMOVE TRANSMISSION VALVE BODY ASSEMBLY
|
(a) Remove the bolt, detent spring cover and detent spring from the transmission valve body assembly. |
|
|
(b) Remove the 12 bolts and transmission valve body assembly from the automatic transmission case sub-assembly. |
|
4. REMOVE MANUAL VALVE
|
(a) Remove the manual valve from the transmission valve body assembly. |
|
5. REMOVE TRANSMISSION CASE GASKET
|
(a) Remove the 2 transmission case gaskets from the automatic transmission case sub-assembly. |
|
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT SHIFT SOLENOID VALVE SL1
(a) Measure the resistance according to the value(s) in the table below.
Text in Illustration
*a
...
Other materials:
Rear Door(for Double Cab)
Components
COMPONENTS
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
Adjustment
ADJUSTMENT
CAUTION / NOTICE / HINT
HINT:
Use the same procedures for both the LH and RH sides.
The procedure described below is for the LH side.
Centering bolts ...
VSC Buzzer Circuit
DESCRIPTION
The skid control ECU (brake actuator assembly) is connected to the combination
meter via CAN communication.
The combination meter has a built-in VSC warning buzzer:
Sounds intermittently to inform the driver if the temperature of brake
actuator assembly has increased exce ...
Light bulbs
You may replace the following bulbs yourself. The difficulty level of replacement
varies depending on the bulb. If necessary bulb replacement seems difficult to perform,
contact your Toyota dealer.
For more information about replacing other light bulbs, contact your Toyota dealer.
■ Prep ...
