Toyota Tacoma (2015-2018) Service Manual: On-vehicle Inspection

Toyota Tacoma (2015-2018) Service Manual / Supplemental Restraint Systems / Front Passenger Side Knee Airbag Assembly / On-vehicle Inspection

ON-VEHICLE INSPECTION

PROCEDURE

1. INSPECT LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle not Involved in Collision)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 2 instrument panel airbag assembly installed on the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag assembly with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag assembly.

2. INSPECT LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (for Vehicle Involved in Collision and Airbag has not Deployed)

(a) Perform a diagnostic system check (See page ).

(b) With the lower No. 2 instrument panel airbag assembly removed from the vehicle, perform a visual check. If there are any defects as mentioned below, replace the lower No. 2 instrument panel airbag assembly with a new one:

Cuts, minute cracks or marked discoloration on the lower No. 2 instrument panel airbag assembly.
Cracks or other damage to the connector.
Deformation or cracks on the instrument panel reinforcement.

CAUTION:

For removal and installation procedures of the lower No. 2 instrument panel airbag assembly, be sure to follow the correct procedure.

Installation

INSTALLATION PROCEDURE 1. INSTALL LOWER NO. 2 INSTRUMENT PANEL AIRBAG ASSEMBLY (a) Connect the airbag connector. NOTICE: When handling the airbag connector, take care not to damage ...

Removal

REMOVAL PROCEDURE 1. PRECAUTION CAUTION: Be sure to read Precaution thoroughly before servicing (See page ). NOTICE: After turning the ignition switch off, waiting time may be required before ...

Other materials:

Mirror Heater does not Operate with Rear Defogger Switch
DESCRIPTION When the mirror heater switch on the air conditioning control assembly is pressed, the operation signal is sent to the air conditioning amplifier assembly. When the air conditioning amplifier assembly receives the signal, it turns on a relay in the air conditioning amplifier assem ...

Vehicle Speed Sensor (C1A45)
DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication. DTC Code DTC Detection Condition Trouble Area C1A45 A fail flag is transmitted from the ...

Transfer Case Front Oil Seal
Components COMPONENTS ILLUSTRATION Replacement REPLACEMENT PROCEDURE 1. DRAIN TRANSFER OIL 2. SUPPORT TRANSMISSION ASSEMBLY 3. REMOVE NO. 3 FRAME CROSSMEMBER SUB-ASSEMBLY 4. REMOVE TRANSFER CASE LOWER PROTECTOR 5. REMOVE FRONT PROPELLER SHAFT ASSEMBLY (See page ) 6. ...