INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact.
PROCEDURE
1. INSTALL BLIND SPOT MONITOR SENSOR LH
(a) Install the blind spot monitor sensor LH with the 3 nuts.
Torque:
9.0 N·m {92 kgf·cm, 80 in·lbf}
(b) Connect the connector.
2. INSTALL BLIND SPOT MONITOR SENSOR RH
HINT:
Use the same procedure as for the LH side.
3. PERFORM BLIND SPOT MONITOR BEAM AXIS INSPECTION
(See page )
4. PERFORM DIAGNOSTIC SYSTEM CHECK
(See page )
5. INSTALL REAR BUMPER EXTENSION LH (w/ Towing Package)
(See page )
6. INSTALL REAR BUMPER EXTENSION LH (w/o Towing Package)
(See page )
7. INSTALL REAR BUMPER EXTENSION RH (w/ Towing Package)
HINT:
Use the same procedure as for the LH side.
8. INSTALL REAR BUMPER EXTENSION RH (w/o Towing Package)
HINT:
Use the same procedure as for the LH side.
9. INSTALL REAR BUMPER PAD SUB-ASSEMBLY (w/ Towing Package)
(See page )
10. INSTALL REAR BUMPER PAD SUB-ASSEMBLY (w/o Towing Package)
(See page )
11. INSTALL CONNECTOR COVER (w/ Towing Package)
(See page )
12. INSTALL REAR BUMPER HOLE COVER (w/o Towing Package)
(See page )
13. INSTALL REAR BUMPER ASSEMBLY (w/ Towing Package)
HINT:
(See page )
14. INSTALL REAR BUMPER ASSEMBLY (w/o Towing Package)
HINT:
(See page )
Emergency flashers
Use the emergency flashers if the vehicle malfunctions or is involved in an
accident.
Press the switch to flash all the turn signal lights. To turn them off, press
the switch once again.
NOTICE
■To prevent battery discharge
Do not leave the emergency flashers on longer than necessary ...
No Signal from Transmitter ID1 (C2121/21-C2124/24,C2181/81-C2184/84)
DESCRIPTION
The tire pressure warning valve and transmitters that are installed in the tire
and wheel assemblies measure the tire pressure of each wheel. The measured values
are transmitted to the tire pressure warning ECU and receiver in the vehicle as
radio waves. The ECU compares the measu ...
Installation
INSTALLATION
PROCEDURE
1. INSTALL OIL COOLER ASSEMBLY (w/ Air Cooled Transmission Oil Cooler)
(a) Install the 2 oil cooler brackets to the oil cooler assembly with the 2 bolts.
Torque:
5.5 N·m {56 kgf·cm, 49 in·lbf}
(b) Install the oil cooler assembly to the vehicle body with th ...