Toyota Tacoma (2015-2018) Service Manual: Installation

Toyota Tacoma (2015-2018) Service Manual / Ac60e Automatic Transmission / Transaxle / Shift Lever / Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION FLOOR SHIFT ASSEMBLY

(a) Install the transmission floor shift assembly to the vehicle body with the 4 bolts.

Torque:

14 N·m {143 kgf·cm, 10 ft·lbf}

(b) Attach the 4 clamps to connect the wire harness to the transmission floor shift assembly.

2. CONNECT TRANSMISSION CONTROL CABLE ASSEMBLY

NOTICE:

Check that the park/neutral position switch and the shift lever are in N.

(a) Push the 2 claws together at the top of the transmission control cable lock piece. While holding the 2 claws together, push the 2 lugs on the bottom of the lock piece toward each other and upward to pull out the lock piece.

Text in Illustration

*1	Lock Piece
*a	Side View
*b	Bottom View
*c	Push

(b) Connect the transmission control cable assembly to the transmission floor shift assembly, and install a new clip.

Text in Illustration

*1	Lock Piece
	Connect in this Direction

NOTICE:

The shift lever should be in N.
Make sure that the lock piece is pulled up.
Push on the end of the cable all the way to the base of the transmission floor shift assembly pin.

(d) Push the lock piece into the adjuster case.

Text in Illustration

*1	Lock Piece
*2	Adjuster Case
*a	Push

NOTICE:

Securely push in the lock piece until it locks.

3. INSPECT SHIFT LEVER POSITION

4. INSTALL FRONT CONSOLE BOX

(See page Reassembly )

Inspection

INSPECTION PROCEDURE 1. INSPECT TRANSMISSION FLOOR SHIFT ASSEMBLY (w/o Smart Key System) HINT: If the results of the following inspections are as specified but a malfunction has occurred, replac ...

Reassembly

REASSEMBLY PROCEDURE 1. INSTALL INDICATOR LIGHT WIRE SUB-ASSEMBLY (a) Connect the connector to install the indicator light wire sub-assembly to the shift position indicator. ...

Other materials:

Automatic Disconnecting Differential Motor Limit Switch Circuit (P17A4)
DESCRIPTION When the A.D.D. actuator switches between 2WD and 4WD, the DL1 and DL2 terminals of the limit switch and ADD terminal of the A.D.D. position switch change to one of the following ON/OFF combinations listed in the table below. Terminal In 2WD Switchi ...

Components
COMPONENTS ILLUSTRATION ILLUSTRATION ILLUSTRATION *1 COMPRESSOR PICK UP SENSOR *2 MAGNET CLUTCH ASSEMBLY *3 PRESSURE RELIEF VALVE *4 COMPRESSOR SPACER *5 O-RING ...

Brake System (P1578)
DESCRIPTION This DTC is stored when a malfunction is detected in the vehicle stability control system. Check the vehicle stability control system when DTC P1578 is stored. DTC No. Detection Item DTC Detection Condition Trouble Area P15 ...