CAUTION / NOTICE / HINT
HINT:
PROCEDURE
1. |
VEHICLE BROUGHT TO WORKSHOP |
|
2. |
INSPECT BATTERY |
(a) Measure the battery voltage with the ignition switch off.
Standard voltage:
11 to 14 V
If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.
|
3. |
CHECK CAN COMMUNICATION SYSTEM* |
(a) Using the Techstream, check if the CAN communication system is functioning normally.
HINT:
Refer to CAN Bus Check in CAN Communication System.
Click here
OK:
CAN communication system is functioning normally.
NG |
GO TO CAN COMMUNICATION SYSTEM |
|
4. |
CHECK FOR DTCs* (FORWARD RECOGNITION CAMERA SYSTEM) |
HINT:
Refer to DTC Check / Clear.
Click here
(a) Check for DTCs and note any codes that are output.
(b) Clear the DTCs.
(c) Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.
Result |
Proceed to |
---|---|
DTCs are not output |
A |
DTCs are output |
B |
B |
GO TO DTC CHART |
|
5. |
PROBLEM SYMPTOMS TABLE |
HINT:
Refer to Problem Symptoms Table.
Click here
Result |
Proceed to |
---|---|
Fault is not listed in Problem Symptoms Table |
A |
Fault is listed in Problem Symptoms Table |
B |
B |
GO TO STEP 7 |
|
6. |
OVERALL ANALYSIS AND TROUBLESHOOTING* |
(a) Terminals of ECU
Click here
(b) Data List / Active Test
Click here
|
7. |
ADJUST, REPAIR OR REPLACE |
NOTICE:
If the forward recognition camera has been replaced with a new one, it is necessary to perform Forward Recognition Camera Axis Adjustment.
Click here
|
8. |
CONFIRMATION TEST |
NEXT |
END |
Downhill Assist Control system
The downhill assist control system helps to prevent excessive speed on steep
downhill descents.
■ System operation
The system will operate when the vehicle is traveling under 15 mph (25 km/h)
and the front-wheel drive control switch is in the L4 position.
Press the DAC switch. The ind ...
Test Mode Procedure
TEST MODE PROCEDURE
1. TEST MODE PROCEDURE (for Using Techstream)
HINT:
If the ignition switch is turned from the ON to the ACC or LOCK position
during test mode, DTCs related to the signal check function will be cleared.
During test mode, the skid control ECU (master cylinder ...
Front Wiper Rubber
Components
COMPONENTS
ILLUSTRATION
Installation
INSTALLATION
PROCEDURE
1. INSTALL FRONT WIPER RUBBER
(a) Install the 2 wiper rubber backing plates to the front wiper rubber.
NOTICE:
Align the groove of the front wiper rubber backing plate with
the edg ...