Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Dtc Check / Clear

DTC CHECK / CLEAR

1. DTC CHECK / CLEAR (when Using Techstream)

(a) Check for DTCs.

(1) Connect the Techstream to the DLC3.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Chassis / ABS/VSC/ TRAC / Trouble Codes.

(5) Read the DTCs by following the prompts on the Techstream screen.

(b) Clear the DTCs.

(1) Connect the Techstream to the DLC.

(2) Turn the ignition switch to ON.

(3) Turn the Techstream on.

(4) Enter the following menus: Chassis / ABS/VSC/ TRAC / Trouble Codes.

(5) Operate the Techstream to clear the codes.

HINT:

Refer to the Techstream operator's manual for further details.

2. END OF DTC CHECK/CLEAR

(a) Turn the ignition switch to ON.

(b) Check that the ABS warning light and slip indicator light go off within approximately 3 seconds.

Diagnosis System
DIAGNOSIS SYSTEM 1. DIAGNOSIS (a) If the skid control ECU (master cylinder solenoid) detects a malfunction, the ABS and/or BRAKE warning lights and the slip indicator lights come on in accordance ...

Fail-safe Chart
FAIL-SAFE CHART 1. FAIL SAFE OPERATION If there is a problem with any sensor signals or hydraulic brake booster systems, the skid control ECU prohibits the power supply to the actuator ...

Other materials:

Checking and replacing fuses
If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. Turn the engine switch to the LOCK position. The fuses are located in the following places. To check the fuses, follow the instructions below. Engine comp ...

Manual Shifting Test
MANUAL SHIFTING TEST 1. PERFORM MANUAL SHIFTING TEST HINT: Using this test, it can be determined whether a problem is in an electrical circuit or if it is a mechanical problem in the transmission. If any abnormalities are found in the following test, the problem is in the tran ...

Disposal
DISPOSAL CAUTION / NOTICE / HINT HINT: The tire pressure warning valve and transmitter is powered by a lithium battery. When disposing of the tire pressure warning valve and transmitter, remove the battery and dispose of it correctly. PROCEDURE 1. DISPOSE OF TIRE PRESSURE WARNING VALVE AND ...

В© 2011-2024 Copyright www.ttguide.net