Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Data List / Active Test

DATA LIST / ACTIVE TEST

1. ACTIVE TEST

HINT:

Using the Techstream to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.

(a) Connect the Techstream to the DLC3.

(b) Turn the ignition switch to ON.

(c) Turn the Techstream on.

(d) Enter the following menus: Body Electrical / Air Conditioner / Active Test.

(e) Perform the Active Test according to the display on the Techstream.

Air Conditioner

Tester Display

Test Part

Control Range

Diagnostic Note

Mirror Heater Relay

Mirror heater operation

ON / OFF

-

Terminals Of Ecu
TERMINALS OF ECU 1. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Automatic Air Conditioning) (See page ) 2. CHECK AIR CONDITIONING AMPLIFIER ASSEMBLY (for Manual Air Conditioning) (See page ) ...

Diagnosis System
DIAGNOSIS SYSTEM 1. CHECK DLC3 (a) Check the DLC3 (See page ). 2. INSPECT BATTERY VOLTAGE (a) Measure the battery voltage. Standard voltage: 11 to 14 V If the voltage is below 11 V, recharge ...

Other materials:

Dtc Check / Clear
DTC CHECK / CLEAR NOTICE: When using the Techstream with the engine switch off, connect the Techstream to the DLC3 and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the Techstream and the vehicle begins. Then select the vehicle type u ...

Poor Sound Quality in All Modes (Low Volume)
PROCEDURE 1. CHECK AUDIO SETTINGS (a) Set Treble, Mid and Bass to the initial values and check that sound is normal. OK: Malfunction disappears. HINT: Sound quality adjustment measures vary according to the type of amplifier. OK END ...

Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE INTAKE VALVE (a) Using SST, compress the inner compression spring and remove the valve spring retainer locks. SST: 09202-70020 SST: 09202-00021 09202-01010 09202-01020 (b) Remove the valve s ...

В© 2011-2024 Copyright www.ttguide.net