PROCEDURE
1. |
CHECK GENERATOR PULLEY WITH CLUTCH (ON-VEHICLE INSPECTION) |
(a) Start the engine and visually check if the fan of the generator rotor assembly located inside the generator assembly is operating.
OK:
The fan of the generator rotor assembly is operating.
NG |
REPLACE GENERATOR PULLEY WITH CLUTCH |
|
2. |
CHECK GENERATOR PULLEY WITH CLUTCH (UNIT INSPECTION) |
(a) Remove the generator assembly (See page ).
(b) Check the installation condition of the generator pulley cap.
OK:
The generator pulley cap is not loose or missing.
(c) Check for grease leaks (for wet pulley) or particle formation due to friction (for dry pulley).
OK:
No grease leaks (for wet pulley) or large build-up of particles (for dry pulley).
(d) Check the generator with clutch pulley for misalignment (interference with the generator assembly).
OK:
The generator pulley with clutch is correctly aligned (no interference with the generator assembly).
(e) Turn the generator pulley with clutch clockwise and counterclockwise by hand and check for noise. OK: Noise does not occur when turned in both directions. |
|
(f) Turn the generator pulley with clutch clockwise and counterclockwise by hand and visually check for runout.
OK:
The generator pulley with clutch does not have runout.
(g) Using a screwdriver, hold the fan of the generator rotor assembly located inside the generator assembly in place and check that the generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise. |
|
OK:
The generator pulley with clutch locks when turned clockwise and turns freely when turned counterclockwise.
OK |
REPAIR OR REPLACE GENERATOR ASSEMBLY |
NG |
REPLACE GENERATOR PULLEY WITH CLUTCH |
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT COOLER CONDENSER ASSEMBLY
(a) If the fins of the cooler condenser assembly are dirty, clean them with water
and dry them with compressed air.
NOTICE:
Do not damage the fins of the condenser assembly.
(b) If the fins of the cooler condenser assembly ...
Power Outlet Socket(for Front Side)
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL
(See page )
2. REMOVE NO. 1 POWER OUTLET SOCKET ASSEMBLY
(a) Using a screwdriver with its tip wrapped in protective tape, disengage
the 2 claws to remove t ...
Test Mode Procedure
TEST MODE PROCEDURE
1. TEST MODE PROCEDURE (for Using Techstream)
HINT:
If the ignition switch is turned from the ON to the ACC or LOCK position
during test mode, DTCs related to the signal check function will be cleared.
During test mode, the skid control ECU (master cylinder ...