Toyota Tacoma (2015-2018) Service Manual: Sending Malfunction (Navigation to APGS) (U0073,U0100,U0140,U0155)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the CAN communication circuit.
|
DTC No. |
DTC Detection Condition |
Trouble Area |
|---|---|---|
|
U0073 |
CAN bus connection error |
CAN communication system |
|
U0100 |
CAN reception error |
|
|
U0140 |
CAN reception error |
|
|
U0155 |
CAN reception error |
PROCEDURE
|
1. |
CHECK DTC |
(a) Clear the DTCs (See page .gif)
).
(b) Recheck for DTCs and check that no DTCs are output.
OK:
No DTCs are output.
| OK | .gif) |
USE SIMULATION METHOD TO CHECK |
| NG | |
GO TO CAN COMMUNICATION SYSTEM |
XM Tuner Antenna Disconnected (B15FE,B15FF)
DESCRIPTION
These DTCs are stored when a malfunction occurs in the antenna assembly with
holder which is connected to the radio and display receiver assembly.
DTC No.
DTC Det ...
Voice Recognition Microphone Disconnected (B1579)
DESCRIPTION
The radio and display receiver assembly and telephone microphone assembly are
connected to each other using the microphone connection detection signal lines.
This DTC is stored when a ...
Other materials:
Bleeding
BLEEDING
CAUTION / NOTICE / HINT
NOTICE:
Wash off brake fluid immediately if it comes in contact with any painted surface.
HINT:
If any work is performed on the clutch system or if there is thought to be air
in the clutch lines, bleed air from the clutch hydraulic system.
PROCEDURE
1. FILL ...
Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION
This DTC is stored when the destination information of the main body ECU (multiplex
network body ECU) does not match that of the blind spot monitor sensors.
DTC Code
DTC Detection Condition
Trouble Area
U1331
Destination in ...
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIATOR GRILLE
(a) w/ Toyota Safety Sense P
(1) Disconnect the connector.
(2) Disengage the clamp.
(b) Put protective tape around the radiator grille.
...
