Toyota Tacoma (2015-2018) Service Manual: Problem Symptoms Table

Toyota Tacoma (2015-2018) Service Manual / Sliding Roof / Sliding Roof System / Problem Symptoms Table

PROBLEM SYMPTOMS TABLE

HINT:

Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
Inspect the fuses and relays related to this system before inspecting the suspected areas below.

Sliding Roof System

Symptom	Suspected Area	See page
Remote Control System does not Operate	Proceed to "Remote Control System does not Operate"
Sliding Roof does not Move by Operating Sliding Roof Control Switch	Proceed to "Sliding Roof does not Move by Operating Sliding Roof Control Switch"
Slide roof warning buzzer malfunction	Meter / gauge system
Slide roof warning buzzer malfunction	Main body ECU (multiplex network ECU)
Slide roof does not move	Sliding roof switch (Roof console box assembly)
	Wire harness or connector	-
	Sliding roof ECU (Sliding roof drive gear sub-assembly)

Initialization

INITIALIZATION 1. INITIALIZE SLIDING ROOF SYSTEM NOTICE: Before starting this operation, make sure that the guide rails are not deformed and there is no foreign matter on the guide rail ...

Terminals Of Ecu

TERMINALS OF ECU 1. CHECK SLIDING ROOF ECU (SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY) (a) Disconnect the S50 sliding roof ECU (sliding roof drive gear sub-assembly) connector. (b) Measure the resis ...

Other materials:

Installation
INSTALLATION CAUTION / NOTICE / HINT HINT: Perform "Inspection After Repairs" after replacing the fuel injector assembly (See page ). PROCEDURE 1. INSTALL FUEL INJECTOR SEAL (a) Apply engine conditioner to the fuel injector assembly area shown in the illustration. U ...

Installation
INSTALLATION PROCEDURE 1. INSTALL PARK/NEUTRAL POSITION SWITCH HINT: Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft. (a) Clean the bolt and bolt ...

Terminals Of Ecu
TERMINALS OF ECU 1. ECM Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition E14-20 (TC) - E11-1 (E1) G - W-B DTC output signal Ignition switch ON ...