New genuine Toyota keys can be made by your Toyota dealer using the other key and the key number stamped on your key number plate.
If the shift lever cannot be shifted from P (vehicles with an automatic transmission)
If the shift lever cannot be shifted with your foot on the brake, there may
be a problem with the shift lock system (a system to prevent accidental operation
of the shift lever). Have the vehicle ...
If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s
battery is discharged.
You can call your Toyota dealer or qualified repair shop.
If you have a set of jumper (or booster ...
Related Tacoma materials
Inspection
INSPECTION
PROCEDURE
1. INSPECT FRONT SUSPENSION LOWER ARM
(a) Flip the ball joint stud back and forth 5 times, as shown in the illustration,
before installing the nut.
(b) Using a torque wrench, turn the nut continuously at a rate of 2 to 4 seconds
per turn and take the torque reading on ...
Calibration
CALIBRATION
1. DESCRIPTION
(a) After replacing any VSC related components or performing wheel alignment
adjustment, clear and read the sensor calibration data.
Refer to the table below and then perform the necessary operation according to
the part to be replaced in order to perform calibratio ...
Head Restraint Adjustment and Removal
Head restraints are provided
for all seats in the Toyota Tacoma and are designed to support proper seating position when adjusted correctly.
WARNING
Head restraint precautions
Observe the following precautions
when using or adjusting the head restraints in the Toyota Tacoma.
Failure to follow these ...