Toyota Tacoma (2015-2018) Service Manual: Deck Light Relay

Toyota Tacoma (2015-2018) Service Manual / Lighting / Deck Light Relay

Inspection

INSPECTION

PROCEDURE

1. REMOVE DECK LIGHT RELAY

(a) Check the resistance.

(1) Measure the resistance according to the value(s) in the table below.

Standard:

Tester Connection	Condition	Specified Condition
3 - 5	Battery voltage is not applied to terminals 1 and 2	10 kΩ or higher
3 - 5	Battery voltage is applied to terminals 1 and 2	Below 1 Ω

If the result is not as specified, replace the deck light relay.

Daytime Running Light Relay

Inspection INSPECTION PROCEDURE 1. INSPECT NO. 1 DAY TIME RUNNING LIGHT RELAY (a) Check the resistance. (1) Measure the resistance according to the value(s) in the table below. St ...

Fog Light Assembly(for Halogen Fog Light)

...

Other materials:

If the vehicle battery is discharged
The following procedures may be used to start the engine if the vehicle’s battery is discharged. You can call your Toyota dealer or qualified repair shop. If you have a set of jumper (or booster) cables and a second vehicle with a 12-volt battery, you can jump start your Toyota following the ...

Removal
REMOVAL PROCEDURE 1. REMOVE NO. 2 ENGINE UNDER COVER SUB-ASSEMBLY (w/ Off Road Package) 2. REMOVE NO. 1 ENGINE UNDER COVER SUB-ASSEMBLY 3. DRAIN ENGINE COOLANT 4. REMOVE RADIATOR GRILLE (See page ) 5. REMOVE EXHAUST MANIFOLD SUB-ASSEMBLY RH (See page ) 6. REMOVE NO. 2 OIL COOLER INLET ...

Inner Rear View Mirror
Components COMPONENTS ILLUSTRATION ILLUSTRATION Calibration CALIBRATION 1. SELECT COMPASS DISPLAY MODE (a) The compass switch allows you to select the Display or Non-display mode of the compass. *1 Compass Switch / EC Control Switch 2. PERFORM CALI ...