Toyota Tacoma (2015-2018) Service Manual: CD cannot be Ejected
PROCEDURE
|
1. |
CHECK OPERATION |
(a) Press the disc eject switch of the radio and display receiver assembly for 5 seconds or more and check that the CD is ejected.
OK:
CD is ejected.
| NG | .gif) |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
|
.gif)
|
2. |
REPLACE CD AND RECHECK |
(a) Replace the CD with a known good one and check that the malfunction disappears.
OK:
CD is ejected.
| OK | |
CD WAS FAULTY |
| NG | |
REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY |
Sound Quality is Bad Only when CD is Played (Volume is Too Low)
PROCEDURE
1.
REPLACE CD AND RECHECK
(a) Replace the CD with a known good one and check that the malfunction disappears.
OK:
Malfunction disappears.
OK
...
CD cannot be Inserted / Played or CD is Ejected Right After Insertion
PROCEDURE
1.
CHECK IF A PROPER CD IS INSERTED
(a) Make sure that the CD is an audio CD or a CD with an MP3, WMA or AAC file,
and that it is not deformed, flawed, st ...
Other materials:
Clearance Sonar Main Switch
Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL
(See page )
2. REMOVE BACK SONAR OR CLEARANCE SONAR SWITCH ASSEMBLY
(a) Disengage the 2 claws to remove the back sonar or clearance sonar
switch assembly.
...
Engine does not Start because No Initial Combustion
DESCRIPTION
When a key is inserted into the ignition key cylinder, the transponder
key coil receives the key ID code and sends it to the transponder key ECU
assembly.
If an error in communication between the transponder key coil and transponder
key ECU assembly occurs, this s ...
Inspection
INSPECTION
PROCEDURE
1. INSPECT MAGNET CLUTCH ASSEMBLY
(a) Inspect the magnet clutch assembly.
Text in Illustration
*a
Component without harness connected
(Magnet Clutch Assembly)
...
