DESCRIPTION
These DTCs are stored when a malfunction occurs in the antenna assembly with holder which is connected to the navigation receiver assembly assembly.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15FE |
The antenna assembly with holder is not connected. |
|
B15FF |
A short occurs in the antenna assembly with assembly |
CAUTION / NOTICE / HINT
NOTICE:
After replacing the stereo component tuner assembly of vehicles subscribed to pay-type satellite radio broadcasts, XM radio ID registration is necessary.
PROCEDURE
1. |
REPLACE ANTENNA CORD SUB-ASSEMBLY |
(a) Replace the antenna cord sub-assembly with a known good one and check if the same DTC is output again (See page ).
(1) Clear the DTCs (See page ).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
END |
|
2. |
REPLACE NO. 2 ANTENNA CORD SUB-ASSEMBLY |
(a) Replace the No. 2 antenna cord sub-assembly with a known good one and check if the same DTC is output again (See page ).
(1) Clear the DTCs (See page ).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
END |
|
3. |
REPLACE ANTENNA ASSEMBLY WITH HOLDER |
(a) Replace the antenna assembly with holder with a known good one and check if the same DTC is output again (See page ).
(1) Clear the DTCs (See page ).
(2) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
END |
NG |
REPLACE STEREO COMPONENT TUNER ASSEMBLY |
Fail-safe Chart
FAIL-SAFE CHART
1. Fail-safe
This function minimizes the loss of operation when any abnormality occurs in
a sensor or solenoid.
Fail-safe Control List
Malfunction Part
Function
Transmission revolution sensor (NT)
During a transmission revolutio ...
Outside rear view mirrors
Mirror angle can be adjusted.
Power-adjustable type
Select a mirror to adjust.
(L: left or R: right)
Adjust the mirror up, down, in or
out using the switch.
Manually adjustable type
Adjust the mirror up, down, in or out by pushing the mirror surface.
Folding back the mirrors
...
Removal
REMOVAL
PROCEDURE
1. REMOVE SHIFT LEVER KNOB SUB-ASSEMBLY (for Automatic Transmission)
(a) Using a molding remover A, disengage the 2 claws to separate the
shifting hole cover sub-assembly.
(b) Rotate the shift lever knob sub-as ...