Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Wireless Charger Main Switch

Toyota Tacoma (2015-2018) Service Manual / Other System / Wireless Charger Main Switch

Components

COMPONENTS

ILLUSTRATION

Removal

Removal

REMOVAL

PROCEDURE

1. REMOVE INSTRUMENT PANEL LOWER CENTER FINISH PANEL

(See page 2. REMOVE MOBILE WIRELESS CHARGER SWITCH )

2. REMOVE MOBILE WIRELESS CHARGER SWITCH

(a) Disengage the 2 claws to remove the mobile wireless charger switch.

Inspection

INSPECTION

PROCEDURE

1. INSPECT MOBILE WIRELESS CHARGER SWITCH

(a) Check the mobile wireless charger switch.

(1) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

11 (ACC) - 8 (SW)

Mobile wireless charger switch is on (not protruding)

Below 1 Ω

Mobile wireless charger switch is off (protruding)

10 kΩ or higher

Text in Illustration

*a

Component without harness connected

(Mobile Wireless Charger Switch)

If the result is not as specified, replace the mobile wireless charger switch.

(b) Check that the switch indicator light illuminates.

(1) Apply battery voltage to the mobile wireless charger switch connector and check the operation of the switch indicator light.

OK:

Connection

Condition

Specified Condition

Battery positive (+) → Terminal 11 (ACC)

Battery negative (-) → Terminal 12 (GND)

Mobile wireless charger switch is on (not protruding)

Switch indicator light illuminates

Mobile wireless charger switch is off (protruding)

Switch indicator light does not illuminates

Text in Illustration

*a

Component without harness connected

(Mobile Wireless Charger Switch)

If the result is not as specified, replace the mobile wireless charger switch.

(c) Check that the switch illuminates.

(1) Apply battery voltage to the mobile wireless charger switch and check that the switch illuminates.

OK:

Connection

Specified Condition

Battery positive (+) → Terminal 10 (ILL+)

Battery negative (-) → Terminal 9 (ILL-)

Illuminates

Text in Illustration

*a

Component without harness connected

(Mobile Wireless Charger Switch)

If the result is not as specified, replace the mobile wireless charger switch.

Installation

INSTALLATION

PROCEDURE

1. INSTALL MOBILE WIRELESS CHARGER SWITCH

(a) Engage the 2 claws to install the mobile wireless charger switch.

2. INSTALL INSTRUMENT PANEL LOWER CENTER FINISH PANEL

(See page Wireless Charging System )

Wireless Charger Assembly
Components COMPONENTS ILLUSTRATION Removal REMOVAL PROCEDURE 1. REMOVE FRONT CONSOLE BOX (See page ) 2. REMOVE MOBILE WIRELESS CHARGER CRADLE ASSEMBLY (a) Remove the 5 sc ...

Wireless Charging System
...

Other materials:

Cruise Control Input Processor (P160700)
DESCRIPTION The ECM continuously monitors its main and sub CPUs. This self-check ensures that the ECM is functioning properly. If outputs from the CPUs are different and deviate from the standard, the ECM will illuminate the MIL and store the DTC. DTC No. Detection Item ...

Check Mode Procedure
CHECK MODE PROCEDURE 1. DESCRIPTION (a) Check mode has a higher sensitivity to malfunctions and can detect malfunctions that normal mode cannot detect. Check mode can also detect all the malfunctions that normal mode can detect. In check mode, DTCs are detected with 1 trip detection logic. ...

Data Signal Circuit between Radio Receiver and Extension Module
DESCRIPTION The stereo component tuner assembly sends the image data signal to the radio and display receiver assembly via this circuit. WIRING DIAGRAM PROCEDURE 1. CHECK NO. 1 NAVIGATION WIRE (a) Disconnect the R33 radio and display receiver assembly connect ...

© 2011-2024 Copyright www.ttguide.net