DESCRIPTION
The navigation receiver assembly and telephone microphone assembly are connected to each other using the microphone connection detection signal lines.
This DTC is stored when the microphone connection detection signal is disconnected.
DTC Code |
DTC Detection Condition |
Trouble Area |
---|---|---|
B1579 |
Telephone microphone signal is lost. |
|
WIRING DIAGRAM
PROCEDURE
1. |
INSPECT NAVIGATION RECEIVER ASSEMBLY |
(a) Remove the navigation receiver assembly with connector still connected.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
NG |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
|
2. |
CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEPHONE MICROPHONE ASSEMBLY) |
(a) Disconnect the N25 navigation receiver assembly connector.
(b) Disconnect the T26 telephone microphone assembly.
(c) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection |
Condition |
Specified Condition |
---|---|---|
N25-6 (SNS2) - T26-3 (SNS2) |
Always |
Below 1 Ω |
N25-19 (MIN-) - T26-4 (MIC-) |
Always |
Below 1 Ω |
N25-6 (SNS2) - Body ground |
Always |
10 kΩ or higher |
N25-19 (MIN-) - Body ground |
Always |
10 kΩ or higher |
NG |
REPAIR OR REPLACE HARNESS OR CONNECTOR |
|
3. |
INSPECT TELEPHONE MICROPHONE ASSEMBLY |
(a) Remove the telephone microphone assembly (See page ).
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
OK |
REPLACE NAVIGATION RECEIVER ASSEMBLY |
NG |
REPLACE TELEPHONE MICROPHONE ASSEMBLY |
On-vehicle Inspection
ON-VEHICLE INSPECTION
PROCEDURE
1. INSPECT CAMSHAFT TIMING GEAR BOLT
(a) Remove the camshaft timing oil control solenoid assembly (See page
).
(b) Check that the plunger strokes when the plunger in the center of
the camshaft timing gear bolt is pressed.
Standard stroke:
4 ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple
suspected areas are listed, the potential causes of the symptoms are listed in order
of probability in the "Suspected Area" column of the table. Check each symptom by
check ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
HINT:
When removing the name plates or stripe tapes, heat the vehicle body or tail
gate and name plates or stripe tapes using a heat light.
Heating Temperature
Item
Temperature
Vehicle Body or Tail Gate
40 to 60 ...