Toyota Tacoma (2015-2018) Service Manual: Voice is not Recognized

Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Audio And Visual System / Voice is not Recognized

PROCEDURE

1.	CHECK CONDITION

(a) Check if the system voice recognition level is low for a particular voice.

Result

Result	Proceed to
System voice recognition level is low for any voice.	A
System voice recognition level is low only for a particular voice.	B

HINT:

System voice recognition level varies depending on voice and pronunciation. This is not a malfunction.
To achieve better voice recognition, ask the customer to watch the tutorial or perform the voice training to train the system.

PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE

END

Voice Guidance does not Function

PROCEDURE 1. CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance setting is not off. OK: Voice guidance setting is not off. NG CHANG ...

Cellular Phone Registration Failure

PROCEDURE 1. CHECK USAGE CONDITION (a) Check that the vehicle and cellular phone meet the following conditions: NOTICE: If changing cellular phone settings, updatin ...

Other materials:

Slave Module Horizontal Axis Misalignment (C1AC2)
DESCRIPTION This DTC is stored when the angle of the blind spot monitor sensor RH deviates more than the allowable range from the horizontal axis. HINT: If drum tester such as a speedometer tester, brake/speedometer combination tester or chassis dynamometer is used with the blind spot monitor ...

LVDS Signal Malfunction (from Extension Module) (B1532)
DESCRIPTION The stereo component tuner assembly and the radio and display receiver assembly are connected by an LVDS communication line. This DTC is stored when an LVDS communication error occurs between the stereo component tuner assembly and the radio and display receiver assembly. ...

Diameter of the Tire is not Uniform (C1337)
DESCRIPTION The skid control ECU (master cylinder solenoid) measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 wheels are operating properly. Therefore, all wheel signals must be equal. DTC No. ...