Toyota Tacoma manuals

Toyota Tacoma (2015-2018) Service Manual: Vehicle Information Not Obtained (C1A02)

DESCRIPTION

When a new millimeter wave radar sensor assembly is installed, it receives vehicle specification information (destination, steering wheel position, 2WD or 4WD, etc.) from the main body ECU (multiplex network body ECU) and stores the information.

DTC C1A02 is stored when the millimeter wave radar sensor assembly cannot store the vehicle specification information from the main body ECU (multiplex network body ECU).

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

C1A02

Vehicle Information Not Obtained

While the ignition switch is ON and the dynamic radar cruise control system is operating, the millimeter wave radar sensor assembly cannot store the vehicle specification information for approximately 0.1 seconds or more.

Millimeter wave radar sensor assembly

Does not come on

CAUTION / NOTICE / HINT

NOTICE:

  • When replacing the millimeter wave radar sensor assembly always replace it with a new one. If a millimeter wave radar sensor assembly which was installed to another vehicle is used, the information stored in the millimeter wave radar sensor assembly will not match the information from the vehicle. As a result, a DTC may be stored.
  • When the millimeter wave radar sensor assembly is replaced with a new one, adjustment of the radar sensor beam axis must be performed.

    Click here

  • First check the CAN communication system by following How to Proceed with Troubleshooting. After checking that there are no malfunctions in the CAN communication system, proceed with troubleshooting.

    Click here

PROCEDURE

1.

CHECK FOR DTC (RADAR CRUISE 2)

(a) Clear the DTCs.

Click here (b) Make sure that the DTC detection conditions are met.

(b) Make sure that the DTC detection conditions are met.

HINT:

If the detection conditions are not met, the system cannot detect the malfunction.

  1. Turn the ignition switch to ON.
  2. Turn the dynamic radar cruise control system on using the cruise control main switch (ON-OFF button).
  3. Wait for 2 seconds or more.

(c) Check for DTCs.

Click here

Result

Proceed to

DTC C1A02 is not output

A

DTC C1A02 is output

B

A

USE SIMULATION METHOD TO CHECK

B

REPLACE MILLIMETER WAVE RADAR SENSOR ASSEMBLY

Front Radar Sensor Region Code Mismatch (C1A0A)
DESCRIPTION When the destination information in the millimeter wave radar sensor assembly and forward recognition camera do not match, DTC C1A0A is stored. DTC No. Detection ...

Clutch Switch Circuit
DESCRIPTION Clutch switch circuit inspection is necessary for manual transmission vehicles. When the clutch pedal is released, the ECM receives the positive (+) battery voltage through the ECU-IG ...

Other materials:

Front Blower Motor
Inspection INSPECTION PROCEDURE 1. INSPECT BLOWER MOTOR (a) Inspect the blower motor. (1) Connect the positive (+) lead from to terminal 1 and negative (-) lead to terminal 2, then check that the motor operates smoothly. CAUTION: Use safety glasses Do ...

Terminals Of Ecu
TERMINALS OF ECU 1. MOBILE WIRELESS CHARGER CRADLE ASSEMBLY Tester Connection Wiring Color Terminal Description Condition Specified Condition M5-1 (ACC) - M5-5 (PGND) GR - W-B Power source (ACC) ...

Data List / Active Test
DATA LIST / ACTIVE TEST 1. DATA LIST HINT: Using the Techstream to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals ...

В© 2011-2024 Copyright www.ttguide.net