Toyota Tacoma (2015-2018) Service Manual: USB Device Malfunction (B1585)

Toyota Tacoma (2015-2018) Service Manual / Audio / Video / Audio And Visual System / USB Device Malfunction (B1585)

DESCRIPTION

This DTC is stored when a malfunction occurs in a connected device.

DTC No.	DTC Detection Condition	Trouble Area
B1585	USB Device Malfunction Non mass-storage class or incompatible protocol USB device USB device with an incompatible file system, corrupted or incompatible File Allocation Table (FAT) "iPod" malfunction "iPod" with unsupported firmware Unsupported "iPod" model	USB device or "iPod" Radio and display receiver assembly

PROCEDURE

1.	REPLACE USB DEVICE OR "iPod"

(a) Disconnect the USB device or "iPod" from the No. 1 stereo jack adapter assembly.

(b) Turn the ignition switch off.

HINT:

When this DTC has been stored, it is necessary to turn off the ignition switch to make it possible for the vehicle to recognize a new device when it is connected.

(d) Connect a known good USB device or "iPod" to the No. 1 stereo jack adapter assembly.

HINT:

If the malfunction occurred when a USB device was in use, use another USB device for the inspection. If the malfunction occurred when an "iPod" was in use, use another "iPod" for the inspection.
Refer to System Description for compatible formats and versions (See page ).

CHECK DTC

(a) Clear the DTCs (See page (b) Recheck for DTCs and check if the same DTC is output again. ).

(b) Recheck for DTCs and check if the same DTC is output again.

OK:

No DTCs are output.

USB DEVICE FORMAT WAS INCOMPATIBLE, "iPod" VERSION WAS INCOMPATIBLE, OR USBDEVICE OR "iPod" WAS DEFECTIVE

REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY

Extension Module Malfunction (B1552,B158A,B15BA)

DESCRIPTION These DTCs are stored when a malfunction occurs in the stereo component tuner assembly. DTC No. DTC Detection Condition Trouble Area B ...

AV Signal Stoppage (Low Battery Voltage) (B158F)

DESCRIPTION This DTC is stored when a video or audio signal is interrupted due to battery voltage input to the radio and display receiver assembly dropping temporarily. DTC Code ...

Other materials:

Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)
DESCRIPTION The skid control ECU (brake actuator assembly) receives signals from the yaw rate and acceleration sensor (airbag sensor assembly) via the CAN communication system. The airbag sensor assembly has a built-in yaw rate and acceleration sensor and detects the vehicle condition. If th ...

Trailer towing
Your vehicle is designed primarily as a passenger-and-load-carrying vehicle. Towing a trailer can have an adverse impact on handling, performance, braking, durability, and fuel consumption. For your safety and the safety of others, you must not overload your vehicle or trailer. You must also e ...

System Description
SYSTEM DESCRIPTION 1. BRIEF DESCRIPTION (a) The Controller Area Network (CAN) is a serial data communication system for real time application. It is a vehicle multiplex communication system which has a high communication speed and the ability to detect malfunctions. (b) Using the CANH and C ...