Components
COMPONENTS
ILLUSTRATION
Inspection
INSPECTION
PROCEDURE
1. INSPECT UNLOCK WARNING SWITCH ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below. Text in Illustration
Standard Resistance:
|
|
Removal
REMOVAL
PROCEDURE
1. REMOVE LOWER STEERING COLUMN COVER
2. REMOVE UPPER STEERING COLUMN COVER
3. REMOVE UNLOCK WARNING SWITCH ASSEMBLY
(a) Insert the key into the ignition key cylinder. Text in Illustration
|
|
(b) Disconnect the connector.
(c) Using a screwdriver with its tip wrapped in protective tape, disengage the 2 claws to remove the unlock warning switch assembly.
Installation
INSTALLATION
PROCEDURE
1. INSTALL UNLOCK WARNING SWITCH ASSEMBLY
(a) Engage the 2 claws to install the unlock warning switch assembly.
(b) Connect the connector.
(c) Remove the key from the ignition key cylinder.
2. INSTALL UPPER STEERING COLUMN COVER
3. INSTALL LOWER STEERING COLUMN COVER
Lost Communication with Front Camera Module (U023A)
DESCRIPTION
These DTCs are stored when the CAN communication system is malfunctioning.
DTC No.
DTC Detecting Condition
Trouble Area
U023A
Lost Communication With Image Processing Module"A"
The main body ECU ...
Stereo Component Amplifier Power Source Circuit
DESCRIPTION
This circuit provides power to the stereo component amplifier assembly.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Inspect the fuses for circuits related to this system before performing the following
inspection procedure.
PROCEDURE
1.
CHECK HARNESS AND CONNE ...
Removal
REMOVAL
CAUTION / NOTICE / HINT
PROCEDURE
1. PRECAUTION
CAUTION:
Be sure to read Precaution thoroughly before servicing (See page
).
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting
the cable from the negative (-) battery terminal. Therefore ...