DESCRIPTION
Refer to TRAC OFF Indicator Light Remains ON (See page ).
WIRING DIAGRAM
Refer to TRAC OFF Indicator Light Remains ON (See page ).
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
CHECK CAN COMMUNICATION SYSTEM |
NG |
GO TO CAN COMMUNICATION SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
|
2. |
INSPECT SKID CONTROL ECU (CSW TERMINAL) |
(a) Disconnect the S1 skid control ECU (master cylinder solenoid) connector.
(b) Measure the resistance according to the value(s) in the table below. Standard Resistance:
|
|
(c) Reconnect the S1 skid control ECU (master cylinder solenoid) connector.
NG |
GO TO STEP 4 |
|
3. |
READ VALUE USING TECHSTREAM (TRAC/VSC OFF MODE) |
(a) Turn the ignition switch off.
(b) Connect the Techstream to the DLC3.
(c) Turn the ignition switch to ON.
(d) Turn the Techstream on.
(e) Enter the following menus: Chassis / ABS/VSC/TRAC / Data List.
ABS/VSC/TRAC
Tester Display |
Measurement Item |
Control Range |
Diagnostic Note |
---|---|---|---|
TRAC/VSC Off Mode |
TRAC/VSC off mode/ Normal, TRC OFF, Unknown or VSC OFF |
Normal: Normal mode TRC OFF: TRAC OFF mode VSC OFF: VSC OFF mode |
- |
(f) Check that the mode display changes according to VSC OFF switch operation.
OK:
Display changes according to switch operation.
OK |
GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING) |
NG |
REPLACE MASTER CYLINDER SOLENOID |
4. |
INSPECT VSC OFF SWITCH |
NG |
REPLACE VSC OFF SWITCH |
|
5. |
INSPECT ROOF CONSOLE BOX ASSEMBLY (MASTER CYLINDER SOLENOID - VSC OFF SWITCH) |
A |
REPAIR OR REPLACE HARNESS OR CONNECTOR (MASTER CYLINDER SOLENOID - ROOF CONSOLE BOX ASSEMBLY) |
B |
REPLACE ROOF CONSOLE BOX ASSEMBLY |
C |
REPLACE ROOF CONSOLE BOX ASSEMBLY |
Listening to a USB memory device
Connecting a USB memory device enables you to enjoy music from the vehicle
speakers.
Select “USB” on the “Select Audio Source” screen.
Connecting a USB memory device
Audio control screen
1. “Select Audio Source” screen appears
2. Displaying the folder list
3. Random playback
4 ...
Sound Signal Circuit between Radio Receiver and Stereo Jack Adapter
DESCRIPTION
The No. 1 stereo jack adapter assembly sends the sound signal from an external
device to the navigation receiver assembly via this circuit.
If there is an open or short in the circuit, sound cannot be heard from the speakers
even if there is no malfunction in the stereo component a ...
How To Proceed With Troubleshooting
PROCEDURE
1.
VEHICLE BROUGHT TO WORKSHOP
NEXT
2.
CUSTOMER PROBLEM ANALYSIS
Click here
NEXT
...