DESCRIPTION
If an ECM that is incompatible with the engine immobiliser system is installed, the ECM stores this DTC.
DTC No. |
DTC Detection Condition |
Trouble Area |
DTC Output Confirmation Operation |
---|---|---|---|
B279C*1 |
An ECM that is incompatible with engine immobiliser system is installed. |
ECM |
Check for DTCs. |
B279C95*2 |
An ECM that is incompatible with engine immobiliser system is installed. |
ECM |
Check for DTCs. |
Vehicle Condition when Malfunction Detected |
Fail-safe Operation when Malfunction Detected |
---|---|
Engine cannot be started |
- |
DTC No. |
Data List and Active Test |
---|---|
B279C*1 |
- |
B279C95*2 |
- |
CAUTION / NOTICE / HINT
NOTICE:
PROCEDURE
1. |
CLEAR DTC |
(a) Clear the DTCs (See page ).
|
2. |
CHECK FOR DTC |
(a) Perform "DTC Output Confirmation Operation" procedure.
(b) Check for DTCs (See page ).
OK:
DTC B279C*1 or B279C95*2 is not output.
Result |
Proceed to |
---|---|
OK |
A |
NG (for 2TR-FE) |
B |
NG (for 2GR-FKS) |
C |
A |
USE SIMULATION METHOD TO CHECK |
B |
REPLACE ECM |
C |
REPLACE ECM |
Invalid Data Received from Vehicle Dynamics Control Module (U0416)
DESCRIPTION
This DTC is detected if a wheel speed malfunction signal is sent from the skid
control ECU (brake actuator assembly).
DTC No.
Detection Item
DTC Detection Condition
Trouble Area
U0416
Invalid Data Received From V ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Check the DTCs.
(1) Turn the ignition switch off.
(2) Connect the Techstream to the DLC3.
(3) Turn the ignition switch to ON.
(4) Turn the Techstream on.
(5) Read the DTCs following the prompts on the Techstream screen. Enter the following
menus: Powertrai ...
Pressure Control Solenoid "G" Performance (Shift Solenoid Valve SL4) (P2808)
SYSTEM DESCRIPTION
The ECM uses the vehicle speed signal and signals from the transmission revolution
sensors (NT, SP2) to detect the actual gear (1st, 2nd, 3rd, 4th, 5th or 6th gear).
The ECM compares the actual gear with the shift schedule in the ECM memory to
detect mechanical problems of t ...