Toyota Tacoma (2015-2018) Service Manual: System Description
SYSTEM DESCRIPTION
1. FUNCTION OF MAIN COMPONENTS
|
Component |
Function |
|---|---|
|
Vertical mirror motor |
Moves the mirror surface vertically in accordance with the vertical mirror motor outer mirror switch assembly operation. |
|
Horizontal mirror motor |
Moves the mirror surface horizontally in accordance with the horizontal mirror motor outer mirror switch assembly operation. |
|
Mirror heater |
When the rear defogger switch on the air conditioning control assembly is operated, the A/C amplifier detects the switch operation via LIN communication. The A/C amplifier operates the integration relay and mirror heater in accordance with the switch operation. |
|
Mirror select switch |
Consists of R and L switches. One must be chosen to operate the outer mirror switch assembly. |
|
Mirror adjust switch |
After selecting the R or L switch, the right, left, up and down control switches can be operated to change the angle of the mirror. |
2. SYSTEM OPERATION
(a) The remote control mirror has the following features:
|
Function |
Outline |
|---|---|
|
Electrical remote control mirror function |
When the outer mirror switch assembly is operated, this function moves the mirror surface vertically or horizontally to enable the driver to attain an optimal mirror angle. Setting the mirror select switch to the R position operates the right mirror, and setting it to the L position operates the left mirror. |
|
Mirror heater function |
Turns on the mirror heaters when the rear window defogger is turned on. The rear window defogger and mirror heaters automatically turn off after 15 min. |
How To Proceed With Troubleshooting
CAUTION / NOTICE / HINT
HINT:
Use the following procedure to troubleshoot the power mirror control
system.
*: Use the Techstream.
PROCEDURE
1.
VEHICLE ...
System Diagram
SYSTEM DIAGRAM
...
Other materials:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
Dtc Check / Clear
DTC CHECK / CLEAR
1. CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON.
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / (desired system) / Trouble Codes.
(e) Check the details of the DTC(s) (See page
).
2. CLEAR DTC
(a) Connec ...
Key Cannot be Registered
DESCRIPTION
A maximum of 5 master key ID codes can be registered.
WIRING DIAGRAM
Refer to "B2780" (See page )
CAUTION / NOTICE / HINT
NOTICE:
If the transponder key ECU assembly is replaced, refer to Registration (See page
).
PROCEDURE
1.
CHECK REGISTRATIO ...
