DESCRIPTION
This DTC is stored when a malfunction occurs in the stereo component amplifier assembly.
DTC No. |
DTC Detection Condition |
Trouble Area |
---|---|---|
B15A3 |
When one of the conditions below is met:
|
Stereo component amplifier assembly |
PROCEDURE
1. |
CHECK DTC |
(a) Clear the DTCs (See page ).
(b) Recheck for DTCs and check if the same DTC is output again.
OK:
No DTCs are output.
OK |
USE SIMULATION METHOD TO CHECK |
NG |
REPLACE STEREO COMPONENT AMPLIFIER ASSEMBLY |
Low Power Supply Voltage Malfunction (C1241)
DESCRIPTION
If there is a problem with the skid control ECU (master cylinder solenoid) power
supply circuit, the skid control ECU outputs the DTC and prohibits operation under
the fail-safe function.
If the voltage supplied to terminal IG1 is not within the DTC detection threshold
due to mal ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table.
Check each ...
Tachometer Malfunction
DESCRIPTION
In this circuit, the meter CPU receives engine speed signals from the ECM using
the CAN communication system (CAN V1 Bus). The meter CPU displays the engine speed
calculated based on the data received from the ECM.
WIRING DIAGRAM
PROCEDURE
1.
CHECK CAN CO ...