Toyota Tacoma (2015-2018) Service Manual: Steering Angle Sensor Zero Point Malfunction (C1290)

Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / Steering Angle Sensor Zero Point Malfunction (C1290)

DESCRIPTION

The skid control ECU (master cylinder solenoid) acquires steering angle sensor zero point every time the ignition switch is turned to ON and the vehicle is driven at 35 km/h (22 mph) or more for approximately 5 seconds. The ECU also stores the previous zero point.

If the front wheel alignment or steering wheel position is adjusted without disconnecting the cable from the negative (-) battery terminal, or if the yaw rate and acceleration sensor zero point is not acquired after the adjustments have been completed, the skid control ECU (master cylinder solenoid) detects the difference between the previous zero point and newly acquired zero point and stores this DTC to indicate poor adjustment.

The steering angle sensor zero point malfunction warning is canceled by turning the ignition switch off.

DTC Code	DTC Detection Condition	Trouble Area
C1290	The steering angle sensor zero point calibration position vastly differs from the recorded value.	Yaw rate and acceleration sensor zero point calibration incomplete Poor adjustment of centered position of steering wheel Poor adjustment of front wheel alignment

PROCEDURE

1.	PERFORM ZERO POINT CALIBRATION OF YAW RATE AND ACCELERATION SENSOR

(a) Perform zero point calibration of the yaw rate and acceleration sensor (See page ).

HINT:

When the stored zero point of the yaw rate and acceleration sensor is cleared, steering angle sensor zero point is also cleared.
If the zero point and output value of the yaw rate and acceleration sensor and the output value of the speed sensors are not normal, steering angle sensor zero point cannot be acquired normally even if the vehicle is driven straight ahead at 35 km/h (22 mph) or more.

2.	CHECK STEERING ANGLE SENSOR ZERO POINT CALIBRATION

(a) Drive the vehicle straight ahead at 35 km/h (22 mph) or more for at least 5 seconds.

(b) Check that the centered position of the steering wheel is correctly set while driving straight ahead.

HINT:

If the front wheel alignment and steering position are adjusted as a result of an abnormal centered position of the steering wheel, acquire the yaw rate and acceleration sensor zero point again after the adjustments are completed.

OK:

The centered position of the steering wheel is correctly set.

END

ADJUST FRONT WHEEL ALIGNMENT OR STEERING POSITION

Center Differential Lock Position Switch (C1282)

DESCRIPTION DTC C1282 is stored only in test mode. DTC Code DTC Detection Condition Trouble Area C1282 Stored during test mode. ...

Diameter of the Tire is not Uniform (C1337)

DESCRIPTION The skid control ECU (master cylinder solenoid) measures the speed of each wheel by receiving signals from the speed sensors. These signals are used for recognizing whether all 4 whee ...

Other materials:

Reassembly
REASSEMBLY CAUTION / NOTICE / HINT HINT: The procedure described below is for the LH side. Use the same procedure for both the LH and RH sides, unless otherwise specified. PROCEDURE 1. INSTALL REAR SEAT CUSHION FRAME SUB-ASSEMBLY (a) Install the rear seat cushion frame sub-assembl ...

Removal
REMOVAL CAUTION / NOTICE / HINT NOTICE: Replace the blind spot monitor sensor if it has been dropped or subjected to a severe impact. PROCEDURE 1. REMOVE REAR BUMPER ASSEMBLY (w/ Towing Package) (See page ) 2. REMOVE REAR BUMPER ASSEMBLY (w/o Towing Package) (See page ) 3. REMOVE CONN ...

Vehicle Speed Sensor (C1A45)
DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU (brake actuator assembly) via CAN communication. DTC Code DTC Detection Condition Trouble Area C1A45 A fail flag is transmitted from the ...