Toyota Tacoma (2015-2018) Service Manual: Sound of Portable Player cannot be Heard from Speakers or Sound is Low
PROCEDURE
|
1. |
CHECK PORTABLE PLAYER SETTINGS |
(a) Check the portable player settings.
(1) Check that the volume is not set to "0".
(2) Check that the mute is off.
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound of the portable player can be heard from the speakers.
| OK | .gif) |
END |
|
.gif)
|
2. |
CHECK AUDIO SETTINGS |
(a) Check the audio settings.
(1) Check that the volume is not set to "0".
(b) Check that the sound of the portable player can be heard from the speakers.
OK:
Sound of the portable player can be heard from the speakers.
| OK | |
END |
|
|
3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check that the sound of the portable player can be heard from the speakers on another "Bluetooth" audio compatible vehicle of the same model.
OK:
Sound of the portable player can be heard from the speakers.
| OK | |
PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE |
| NG | |
MALFUNCTION IN PORTABLE PLAYER |
Confirm Vehicle Headunit Functionality
PROCEDURE
1.
CHECK CUSTOMER'S CELLULAR PHONE COMPATIBILITY
(a) Go to TIS "Bluetooth" Compatibility Portal and check if the cellular phone
is compatibl ...
Does not Play even after Bluetooth Audio Mode is Selected
CAUTION / NOTICE / HINT
HINT:
Even if the portable player can play audio content, it may not be able to play
via the in-vehicle device. This does not necessarily indicate a malfunction of the
in ...
Other materials:
Acceleration Sensor Malfunction (C1420)
DESCRIPTION
Refer to DTCs C1419 and C1435 (See page ).
DTC Code
DTC Detection Condition
Trouble Area
C1420
After the difference between GL1 and GL2 becomes 0.6 G or more with the
vehicle stationary, the difference remains 0.4 G or m ...
Reverse Signal Circuit
DESCRIPTION
The radio and display receiver assembly*1 or navigation receiver assembly*2 receives
a reverse signal from the park/neutral position switch*3 or the back-up light switch
assembly*4.
*1: w/o Navigation System
*2: w/ Navigation System
*3: for Automatic Transmission
...
Inspection
INSPECTION
PROCEDURE
1. INSPECT WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
HINT:
The valve opening temperature is inscribed on the water inlet with thermostat
sub-assembly.
(a) Immerse the thermostat in the water, then heat the water gradually.
CAUTION:
Do not your hands into the wa ...
