Toyota Tacoma (2015-2018) Service Manual: SM Solenoid Circuit (C1225-C1228,C1468,C1469,C146A,C146B)

Toyota Tacoma (2015-2018) Service Manual / Brake Control / Dynamic Control Systems / Vehicle Stability Control System(for Hydraulic Brake Booster) / SM Solenoid Circuit (C1225-C1228,C1468,C1469,C146A,C146B)

DESCRIPTION

The solenoid goes on when signals are received from the skid control ECU (master cylinder solenoid) and controls the pressure action on the wheel cylinders thus controlling the braking force.

DTC No.	DTC Detecting Conditions	Trouble Areas
C1225	Open or short in SMCR circuit continues for 0.05 seconds or more.	Master cylinder solenoid SMCR circuit
C1226	Open or short in SREA circuit continues for 0.05 seconds or more.	Master cylinder solenoid SREA circuit
C1227	Open or short in SREC circuit continues for 0.05 seconds or more.	Master cylinder solenoid SREC circuit
C1228	Open or short in STR circuit continues for 0.05 seconds or more.	Master cylinder solenoid STR circuit
C1468	Open or short in SFRH or SFRR circuit continues for 0.05 seconds or more.	Master cylinder solenoid SFRH or SFRR circuit
C1469	Open or short in SFLH or SFLR circuit continues for 0.05 seconds or more.	Master cylinder solenoid SFLH or SFLR circuit
C146A	Open or short in SRRH or SRRR circuit continues for 0.05 seconds or more.	Master cylinder solenoid SRRH or SRRR circuit
C146B	Open or short in SRLH or SRLR circuit continues for 0.05 seconds or more.	Master cylinder solenoid SRLH or SRLR circuit

WIRING DIAGRAM

PROCEDURE

1.	RECONFIRM DTC

HINT:

This DTCs are set when a problem is identified in the master cylinder solenoid.

The solenoid circuit is in the master cylinder solenoid.

Therefore, solenoid circuit inspection and solenoid unit inspection cannot be performed. Be sure to check if the DTCs are output before replacing the master cylinder solenoid.

(a) Clear the DTC (See page (b) Check if the same DTCs are detected. ).

(b) Check if the same DTCs are detected.

Result	Proceed to
DTC output	A
DTC not output	B

REPLACE MASTER CYLINDER SOLENOID

END

Zero Point Calibration of Yaw Rate Sensor Undone (C1210,C1336)

DESCRIPTION The skid control ECU (master cylinder solenoid) receives signals from the yaw rate and acceleration (airbag sensor assembly) via the CAN communication system. The airbag sensor assembl ...

Acceleration Sensor Stuck Malfunction (C1232,C1243,C1245,C1279)

Other materials:

Road Test
ROAD TEST PROBLEM SYMPTOM CONFIRMATION HINT: The dynamic radar cruise control system has 2 cruise control modes: constant speed control mode and vehicle-to-vehicle distance control mode. Vehicle-to-vehicle distance control mode is selected by default when the dyna ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSION HINT: The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engin ...

Precaution
PRECAUTION 1. IGNITION SWITCH EXPRESSIONS (a) The type of ignition switch used on this model differs according to the specifications of the vehicle. The expressions listed in the table below are used in this section. Expression Ignition Switch (Position) Engine ...