Toyota Tacoma (2015-2018) Service Manual: Sliding Roof
- Sliding Roof Housing
- Sliding Roof Switch Assembly
- Sliding Roof System
- Precaution
- Parts Location
- System Description
- System Diagram
- Customize Parameters
- How To Proceed With Troubleshooting
- Operation Check
- Initialization
- Problem Symptoms Table
- Terminals Of Ecu
- Data List / Active Test
- Diagnosis System
- Dtc Check / Clear
- Switch Failure (B2342)
- Position Initialization Incomplete (B2343)
- Diagnostic Trouble Code Chart
- Sensor (Motor) Failure (B2341,B2344)
- Remote Control System does not Operate
- Sliding Roof does not Move by Operating Sliding Roof Control Switch
Front Passenger Side Seat Belt Warning Light Malfunction
DESCRIPTION
The occupant classification ECU detects the state of the front seat inner belt
assembly RH and load sensor when the front passenger side seat is occupied with
the ignition switch ON. ...
Other materials:
Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION
The navigation receiver assembly sends a sound signal to the stereo component
amplifier assembly via this circuit.
The sound signal that has been sent is amplified by the stereo component amplifier
assembly, and then is sent to the speakers.
If there is an open or short in the cir ...
High Power Supply Voltage Malfunction (C1417)
DESCRIPTION
If a malfunction is detected in the power supply circuit, the skid control ECU
(brake actuator assembly) stores this DTC and the fail-safe function prohibits ABS
operation.
This DTC is stored when the +BS terminal voltage deviates from the DTC detection
condition due to a malfunc ...
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms.
If multiple suspected areas are listed, the potential causes of the symptoms
are listed in order of probability in the "Suspected Area" column of the
table. Check each sy ...
