Components
COMPONENTS
ILLUSTRATION
Removal
REMOVAL
PROCEDURE
1. REMOVE RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
(See page )
2. REMOVE NO. 1 NAVIGATION WIRE
(a) Disconnect the 6 connectors to remove the No. 1 navigation wire. |
|
3. REMOVE NO. 1 RADIO RECEIVER BRACKET
(a) Remove the 5 bolts and No. 1 radio receiver bracket. |
|
4. REMOVE NO. 2 RADIO RECEIVER BRACKET
(a) Remove the 5 bolts and No. 2 radio receiver bracket. |
|
5. REMOVE STEREO COMPONENT TUNER ASSEMBLY
(a) Disengage the 2 guides to remove the stereo component tuner assembly as shown in the illustration. |
|
Installation
INSTALLATION
PROCEDURE
1. INSTALL STEREO COMPONENT TUNER ASSEMBLY
(a) Engage the 2 guides to install the stereo component tuner assembly.
2. INSTALL NO. 2 RADIO RECEIVER BRACKET
(a) Install the No. 2 radio receiver bracket with the 5 bolts.
Torque:
2.5 N·m {25 kgf·cm, 22 in·lbf}
3. INSTALL NO. 1 RADIO RECEIVER BRACKET
(a) Install the No. 1 radio receiver bracket with the 5 bolts.
Torque:
2.5 N·m {25 kgf·cm, 22 in·lbf}
4. INSTALL NO. 1 NAVIGATION WIRE
(a) Connect the 6 connectors to install the No. 1 navigation wire.
5. INSTALL RADIO AND DISPLAY RECEIVER ASSEMBLY WITH BRACKET
(See page )
Parts Location
PARTS LOCATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
ILLUSTRATION
...
Open in Turn Signal Circuit (B1507,B1508)
DESCRIPTION
This DTC is stored when the combination meter assembly detects an open in a turn
signal light circuit, a short in a turn signal light circuit, or a short in the
hazard warning light circuit.
DTC No.
DTC Detection Condition
Trouble Area
...
Vehicle Lift And Support Locations
VEHICLE LIFT AND SUPPORT LOCATIONS
1. NOTICE ABOUT VEHICLE CONDITION WHEN JACKING UP VEHICLE
(a) The vehicle must be unloaded before jacking up / lifting up the vehicle.
Never jack up / lift up a heavily loaded vehicle.
(b) When removing heavy parts such as the engine and transmission, the cent ...